Hyundai H-1419 User manual

Category
CD players
Type
User manual
CD/MP3/USB-
СТЕРЕОМАГНИТОЛА
CD/MP3/USB/RADIO
PLAYER
Руководство по эксплуатации Instruction manual
H-1419
2
Instruction manual
Dear customer!
Thank you for purchasing our product. For safety, it is strongly recommended to read
this manual carefully before connecting, operating and/or adjusting the product and keep
the manual for reference in future.
Description
1. M+/FOLDER+ button
2. EQ button
3. MUTE button
4. Disc compartment cover
5. IR sensor
6. LCD display
7. PLAY/PAUSE/FM MODE button
8. BACK/TUNE DOWN button
9. PLAYMODE button
10. FUNCTION button
11. ON/OFF button
12. USB slot
13. Handle
14. NEXT/TUNE UP button
15. PROG button
16. STOP button
17. VOL.UP button
18. VOL.DN button
19. M-/FOLDER- button
20. BASS button
21. SLEEP button
Not indicated:
Battery compartment (bottom panel)
Telescopic FM antenna (back panel)
Power cord socket (back panel)
AUX input (back panel)
1 2 3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19 20 21
3
Instruction manual
Utilization of the product
If you want to dispose this product, do not
mix it with general household waste. There is a
separate collection system for used electronic
products in accordance with legislation that
requires proper treatment, recovery and
recycling.
Please contact your local authorities for
the correct method of disposal. By doing so,
you will ensure that your disposed product
undergoes the necessary treatment, recovery
and recycling and thus prevent potential
negative effects on the environment and
human health.
Important safeguards
Attention: The owner’s manual contains
important operating and maintenance
instructions. For your safety, it is necessary to
refer to the manual.
Dangerous voltage: Uninsulated
dangerous voltage that may be of sufficient
magnitude to constitute a risk of electrical
shock to persons is present within this product
enclosure.
Caution: To reduce the risk of electric
shock, do not dismantle the body. Prefer
servicing to qualified service personnel. Do not
use the unit in places where it can be exposed
to water, moisture and dust. Make sure that
pins or other foreign objects do not get inside
the unit; they may cause malfunctions, or
create safety hazards such as electrical shock.
Power supply
Battery operation
• Open the battery compartment cover.
• Insert 6 x UM-2/LR14 batteries. Please
observe correct battery polarities or the set will
not work.
Remote controller
1. BASS button
2. EQ button
3. PROGRAM button
4. FUNCTION button
5. PLAY/PAUSE/FM MODE button
6. BACK/TUNE- button
7. STOP button
8. PLAY MODE button
9. MUTE button
10. MEM+/FOLDER+ button
11. MEM-/FOLDER- button
12. NEXT/TUNE+ button
13. VOLUME+ button
14. SLEEP button
15. VOLUME- button
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
4
Instruction manual
• Close the battery compartment cover.
AC operation
• Before the first connecting of the appliance
check that voltage indicated on the rating label
corresponds the mains voltage in your home.
• Plug the corresponding end of cord into
the AC socket on the rear of the set.
• Insert the plug into power supply.
Caution:
• When the set is only used with AC or is
not used for 2 weeks or more, please remove
the batteries, to avoid damage to the set from
leakage of batteries.
• Always switch off the unit when not in use.
• Always unplug the appliance from power
supply, when no use long time.
General operations
Power on/off
Press ON/OFF button on the unit or POWER
button on the RC to switch on the unit. Press
this button to switch off the unit.
Electronic volume control
• This unit uses an electronic volume control.
To increase or decrease the loudness of unit,
press respectively VOL.UP/VOL.DN buttons
on the unit or VOL UP/VOL DOWN buttons on
the RC.
• Volume loudness level is indicated in the
LCD display in 30 steps (0 = minimum, 30 =
maximum).
Music equalizer
Press EQ button repeatedly to choose
the desired sound effect according to the
music you are listening to: FLAT (EQ off) =>
CLASSIC => ROCK => POP => JAZZ.
Automatic power off (sleep) function
• This set has a special sleep timer function
which can automatically switch off the unit.
• At any time while the unit is operating
(CD player or radio), press SLEEP button
repeatedly to choose the automatic power off
time: 90 min => 80 min => 70 min => 60 min
=> 50 min => 40 min => 30 min => 20 min =>
10 min => OFF.
Bass enhancement
Press BASS button to enhance bass
frequencies. Press the button again to
deactivate the function.
Mute
Press MUTE button to mute the sound.
Press the button again or adjust the volume to
resume sound output.
Radio operation
• Press repeatedly FUNCTION button until
the display shows FM.
• Press and hold NEXT/TUNE-UP button or
BACK/TUNE-DOWN button; the fast scanning
starts. The frequency will continue to change
and will automatically stop when a broadcast
station is received.
• To receive a weak broadcast signal
press repeatedly NEXT/TUNE-UP button or
BACK/TUNE-DOWN button on and adjust the
frequency you wish to receive.
Saving stations to memory
• 30 FM broadcast stations can be stored to
the preset memory.
• During tuner mode, find a desired station.
• Press PROG button on the unit or PROG
button on the RC to activate memory setting
mode.
• Press MEM-/FOLDER- button or MEM+/
FOLDER+ button to choose the desired
memory location. The location number is
flashing on the left side of the screen.
• Press PROG button on the unit or PROG
button on the RC button again to store the
desired station.
• Repeat steps for storing stations to other
locations.
5
Instruction manual
• To clear the memory of any location simply
save a new station to the same memory.
Selecting stored stations
Press repeatedly -MEM-/FOLDER- button
or MEM+/FOLDER+ button to choose the
memory location. The stored station will be
selected.
Antenna
• For FM reception, adjust the telescopic
antenna appropriately to obtain the best
reception on the band selected.
FM mono and FM stereo reception
In particular when stereo signal is weak and
much noise are received, it is preferable to
receive the program in mono. Press FM-MODE
button to switch between FM stereo and mono
modes.
Compact disc operations
Insertion and removal of discs
• When opening the CD-door, always
ensure the disc is not in motion (not spinning)
when you open the CD-door. Always press
STOP button to stop the disc spinning first.
• Place a CD into the compartment with the
label-side (printed side of disc) facing upwards.
Press down in the center part of disc until the
disc “locks” onto the center spindle.
• When the CD has been placed onto the
center spindle, gently lower the CD-door
downwards until it locks shut. The CD is now
ready to be played.
• To remove a disc, follow the same
procedure as described above, except to
remove the CD instead of inserting it into the
compartment, by placing one finger at the
middle of disc (center spindle) & the other at
the edge of the disc & gently pulling upwards.
Please make sure to always fold down
the handle before opening the CD door.
• Press CD button to enter CD mode.
• Put a disc into the CD compartment and
close the CD door.
• The display will indicate “READ” for a few
seconds and then start to play the first track.
• The display will indicate the current track
number and playback time.
Play/pause mode
• Press PLAY/PAUSE button to pause at
any track when playing. Press PLAY/PAUSE
button again to resume playing.
• To stop the disc, press STOP button.
If you press PLAY/PAUSE button now the
playback will start from first track.
Skip and search mode
• Press NEXT/TUNE UP button to skip to
the next track. Press and hold this button to
search for a particular point at high speed
forward. Release the button to resume normal
play.
• Press BACK/TUNE DOWN button to the
beginning of the current track. Press twice
BACK/TUNE DOWN button on the unit to skip
back to previous track. Press and hold this
button to search for a particular point at high
speed backward. Release the button to resume
normal play.
Repeat and random modes
Press repeatedly PROG button on the unit
or PLAY MODE button on the RC to select the
following options:
- REPEAT – to repeat the current track
- REPEAT ALL – to repeat all tracks (full
CD, USB or SD)
- RANDOM – to play a random mix of all the
songs on CD/USB.
Program mode
• Up to 60 tracks can be programmed for
disc play in any order or the same track can be
repeated up to 60 times.
• Before use, be sure to stop the disc by
pressing STOP button.
• Press PROG button on the unit or PROG
6
Instruction manual
button on the RC. The display will show “P01”.
This indicates that the set is now in memory
programming mode, at the first memory
position.
• Select a desired track by using BACK/
TUNE DOWN and NEXT/TUNE UP buttons.
• Press PROG button on the unit or PROG
button on the RC to confirm.
• The set will advance to next memory
position, the display will show “P02”.
• Repeat steps described above to enter
other memories into the program if necessary.
• After a maximum of 60 songs (or less)
have been selected as described above,
press PLAY/PAUSE button to start playing the
programmed tracks.
• The “PROG” symbol will appear to indicate
that you have saved a program-memory
(sequence).
• The program memory will be cleared when
you press STOP button twice.
MP3 operation
• You can use M+/FOLDER+ button on the
unit or MEM+/FOLDER+ button on the RC to
jump 10 songs ahead or M-/FOLDER- button
on the unit or MEM-/FOLDER- button on the
RC to jump 10 songs backward. This is useful
if you have many songs and you want to
quickly jump to a particular song.
• Press repeatedly M+/FOLDER+ button
or M-/FOLDER- button on the unit or MEM-/
FOLDER-or MEM+/FOLDER+ buttons on the
RC until you reach a song number near to
your desired song, and then press repeatedly
BACK/TUNE DOWN or NEXT/TUNE UP
buttons to arrive and the exact song you
desire.
• If your disc has folders, you can select the
folder to playback. Press M+/FOLDER+ button
on the unit or MEM+/FOLDER+ button on the
RC to switch to the next folder. The set will
start playing the first song in the next folder.
• If the set is in “STOP” mode and you press
MEM+/FOLDER+ button, the unit will switch
to the next folder but the playback will not start
automatically. Press PLAY/PAUSE button to
start playback.
Good quality sound is guaranteed only
when playing licensed MP3 discs.
USB operations
• This unit is equipped with a USB socket
which can accept and play MP3 files stored
on standard USB flash (compatible with USB
version 1.1 & 2.0) up to 16 GB.
• To use USB drives cards for MP3 playback
insert the USB drive into the appropriate socket
and press FUNCTION button until the display
shows “USB”.
• If MP3 files are found the set will start
playback of the first file.
• Playback control is same as for discs.
Always switch off the unit or change
mode to “CD” or “RADIO” before removing a
USB flash drive to prevent damage to your
USB device.
Attention: Although this product is fully
compatible with USB 1.1 & 2.0 standard
formats, a small percentage of USB flash
drives might not be readable, due to those
device manufacturers non-compliance with the
full (official) USB standards.
According to the USB 1.1/2.0 Standard,
usage of a USB device with power current
consumption exceeding 500 mA is not
recommended without supplementary power
supply. Failure to use supplementary power for
connected USB drives with power consumption
exceeding this value as well as defective
USB drives may cause mechanical or thermal
changes of elements of this unit as well as
failure of internal elements of the USB port.
Such damages are not warrantee cases.
Warning: usage of external USB drives
containing BIN files in the root directory may
cause malfunction of the unit or damage to the
software.
7
Instruction manual
AUX jack
You can connect the audio output of an
external device to this unit, to listen to the sound
of that device through the speakers of this unit.
• To connect an external audio device,
please use a standard audio cable with 3.5-mm-
to-3.5 mm plugs (not included) to connect the
headphone out or audio line-out of the external
device to the AUX input socket of this unit.
• Press FUNC button repeatedly to select
AUX mode; AUX icon will be displayed.
• Turn on the external device. You cannot
control playback with the buttons of this unit
except adjusting the volume.
Maintenance and care
• Check your batteries regularly, old or
discharged batteries should be replaced. If the
unit is not going to be used for some time or is
being run exclusively on the alternative power,
remove the batteries to avoid leakage and
damage.
• Electronic products of this kind should
never be subjected to moisture or extreme
temperatures.
• Do not use the unit in places where it can
be exposed to water, moisture and dust.
• If necessary, clean the unit with a piece of
cloth dampened with water only (be sure the
AC power cord is disconnected from the power
supply).
• When pick up the CD disc, always hold the
edge of the disc, never touch the surface of the
disc, it would scratch the disc surface and may
occur sound distortion or raise reading problem.
Accessories
Radio player 1 pc
Power cord 1 pc
Remote controller 1 pc
Instruction manual 1 pc
Warranty card 1 pc
Consumer information 1 pc
8
Instruction manual
Specifications
Supported formats MP3, CDDA
Supported storage CD/CD-R/CD-RW/USB
Nominal voltage 220 V, 50 Hz
Battery power supply 9 V (6 х UM2/LR-14 batteries 1.5 V)
Output power, RMS 2 x 2 W
Nominal power consumption 15 W
FM frequency range 87.5 - 108 MHz
Presettable stations 30
Net/Gross weight 1.95 kg/2.2 kg
Unit dimensions (L x W x H) 220 mm x 245 mm x 138 mm
Specifications and functions are subject to change without notice. It is connected with continual
improvement of the device.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16

Hyundai H-1419 User manual

Category
CD players
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI