2. Put the power supply of accessories into 86 boxes and connect the 220V mains wire with the wire L and N of the accessories;(where

input: brown L, blue N;Output: 2 pin jack, red L, black N;Note: please disconnect the 220V power supply when wiring.

3. Connect the output of the accessory power supply and the power input of the multi-function touch panel as shown below.

4. Lock the wall bracket as shown below on the transit box through the _tting screw (note that the arrow is up in the correct direction)

5. Insert the product power wire and output wire of the power supply through the terminal and tilt the product at a certain Angle.

Fasten the upper button and then press the lower end of the product

1 . Press "Setting" into setting page.

2. Press " Join" into next page.

3. Long press " Reset" for 8 second to restore original state.

1 . Press the button of "Setting" on the Wireless LCD Control Panel.