WHILE-IN-USE COVER DESCRIPTION

This product is a weatherproof cover that is intended to enclose an electrical device (outlet, GFCI, switch, etc.) and protect the device from

inclement weather even when a plug and cord are inserted in it. It is designed to install quickly and easily (see instructions below) and

provide an attractive, durable finish that will yield long-lasting results.

APPLICATION

The cover should be installed in areas subject to saturation from water or other liquids (see description for “Wet Location” and “Damp

Location” in the National Electrical Code). The cover can be mounted horizontally or vertically, as long as the hinge is in the top corner.

WARNING – Turn off all power to circuit before installing this device. Improper wiring of any electrical device can cause serious injury

are no obstructions on the opposite side of wall.

3) Hold Cover against wall and use back as a template for a 4.25" X 6" cutout or use template below.

4) Drill a hole and cut out the opening.

5) Pull the wires through the opening and insert into the appropriate cable entries.

6) Mount product to a solid surface on the structure with latch pointing down using the four #8 screws

provided. (See illustrations.) Do not over tighten screws.

7) Install device and wall plate as per the appropriate instructions.

8) Insure that the mud cover is in place to protect the Cover. Remove the mud cover after stucco

and painting is complete.

9) For best rain protection, be sure to route cords through the cord outlet and press the cover firmly