KD-S35
Installation/Connection Manual
Manual de instalación/conexión
GET0563-002A
[J]
PREPARATIONS
You need the installation kits which corresponds to your car.
• Mark all the check boxes ( ) to make sure you have follow the instructions and the listed parts.
Check the battery system in your car
Prepare this before installation
1
0508DTSMDTJEIN
EN, SP
© 2008 Victor Company of Japan, Limited
ENGLISH
ESPAÑOL
12 V DC, NEGATIVE ground
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• Noise interfere with sounds.
* Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?
• This unit becomes hot.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• This unit does not work at all.
* Have you reset your unit?
TROUBLESHOOTING
A/B
Hard case/
Control panel
C
Sleeve
D
Trim plate
E
Power cord
K
Handles
J
Rubber cushion
I
Mounting bolt—
M4 × 5 mm (M4 × 1/4");
M5 × 12.5 mm (M5 × 1/2")
H
Lock nut (M5)
G
Washer (ø5)
Parts list for installation and connection
L
Remote controller
M
Battery
When using the optional stay
Install the unit at an angle of
less than 30˚.
Screw (option)
Stay (option)
Fire wall
Dashboard
* Not supplied for this unit.
Flat type screws
—M5 × 8 mm (M5 × 3/8")*
Pocket
Flat type screws
—M5 × 8 mm (M5 × 3/8")*
Bracket*
Bracket*
Removing the unit
In dash-mounting
Before removing the unit, release the rear section.
When installing the unit without using the sleeve
In a Toyota car for example, first remove the car radio and install the unit in its place.
Do the required electrical
connections.
Bend the appropriate tabs
to hold the sleeve firmly
in place.
When you stand the unit, be careful
not to damage the fuse on the rear.
INSTALLATION
If you are not sure how to install this unit correctly, consult your JVC car audio dealer.
F
Direct connection
cable for iPod
Install_EN_KD-S35[J]_1.indd 1Install_EN_KD-S35[J]_1.indd 1 6/5/08 4:41:33 PM6/5/08 4:41:33 PM
Set “L/O MODE” to “SUB. W”
(See page 15 of the INSTRUCTIONS.)
Remote lead (blue with white stripe)
To the remote lead of other equipment
or automatic antenna if any
Y-connector *
1
Front speakers
Subwoofer
Set “L/O MODE” to “REAR”
(See page 15 of the
INSTRUCTIONS.)
JVC Amplifier
JVC Amplifier
Rear speakers
or
Remote lead
Remote lead
2
Purple
Front speaker (left)
To the remote lead of other
equipment or automatic antenna if
any (200 mA max.)
Blue with white
stripe
Red
To an accessory terminal in
the fuse block
To a live terminal in the
fuse block connecting to the
car battery (bypassing the
ignition switch) (constant
12 V)
Yellow *
2
To metallic body or
chassis of the car
Black
Ignition switch
*
1
Not supplied for this unit.
*
2
Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be
turned on.
*
3
Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place not coated with paint (if
coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.
*
4
Signal cord (not supplied for this unit).
15 A fuse
Fuse block
Rear speaker (left)
Rear speaker (right)
Front speaker (right)
White with black stripe
Rear ground terminalAntenna terminal
Gray with black stripe
Green
Gray
Green with black stripe
Purple with black stripe
White
ELECTRICAL CONNECTIONS
Typical connections Connecting the external amplifiers and/or subwoofer
Make sure to disconnect the battery’s negative terminal.
• Be sure to ground this unit to the car’s chassis again after installation.
Note:
It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 Ω to 8 Ω).
If the maximum power is less than 50 W, change “AMP GAIN” setting to prevent the speakers from being damaged (see page 15 of the INSTRUCTIONS).
Heat sink
High
Connect only the front speakers if your
speaker system is two-speaker system.
PRECAUTIONS on power supply and speaker connections
Connecting an Apple iPod
iPod connector
You can connect an iPod to this unit using the supplied direct connection cable for iPod.
Apple iPod (separately purchased)
Direct connection cable for iPod (supplied)
iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
Rear line out
Install_EN_KD-S35[J]_1.indd 2Install_EN_KD-S35[J]_1.indd 2 6/5/08 4:41:36 PM6/5/08 4:41:36 PM
Page is loading ...
Page is loading ...
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- español: JVC KD-S35 Manual de usuario
Related papers
-
JVC KD-APD38 Installation guide
-
-
-
-
-
-
-
-
-