Safety instructions
14
e
z Only connect the device as follows:
– With the cable supplied (fig. 1 2, page 3) to the cigarette
lighter or a 12 V plug socket in the vehicle
– Alternatively, with the cable supplied (fig. 1 2, page 3) to
the cigarette lighter or a 12 V socket in the vehicle
z Never pull the plug out of the 12 V or 24 V socket socket by the
cable.
z If the connection cable is damaged, it must be replaced with
the cable of the same type and specifications.
z Disconnect the plug:
– Before cleaning and maintenance
– After use
z On boats: if the device is powered by the mains, ensure that the
power supply has a ground fault interrupter circuit. Danger of
fatal injuries!
z Disconnect the cooling device and other power consuming de-
vices from the battery before connecting the quick charging de-
vice.
z Check that the voltage specification on the type plate corre-
sponds to that of the energy supply.
1.2 Operating the device safely
a
z Before starting the device, ensure that the power supply line
and the plug are dry.
z Do not place the device near naked flames or other heat sourc-
es (heaters, direct sunlight, gas ovens etc.).
z Caution! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the
heat that arises during operation does not build up. Make sure
that the device is sufficiently far away from walls and other ob-
jects so that the air can circulate.
z Do not fill the inner container with ice or fluid.
z Never immerse the device in water.
z Protect the device and the cable against heat and moisture.
z Do not touch exposed cables with your bare hands. This espe-
cially applies when operating the device with an AC mains pow-
er supply. Danger of fatal injuries!
_AT-35.book Seite 14 Freitag, 17. September 2010 11:48 11