Ampire SP100 Owner's manual

SP100
Ampire
Brand
Ampire
Model
SP100
Type
Owner's manual

This manual is also suitable for

ampire
SP100
SP130
SP165
German Engineering. Out of the ordinary.
Owner’s Manual
English
Before attempting to connect or operate this product, please read the instructions completely.
2
Electronics – Irrtum und technische Änderungen vorbehalten
ampire
2016
Precautions
Warranty
• Pay utmost attention if you install the loudspeakers into the driver’s compartment.
• Use only on minimum 4 ohm stable devices.
• Make the correct connections.
• Do not damage pipe or wiring when drilling holes.
• Arrange the wiring so it is not crimped or pinched by a sharp metal edge.
• Do not install the loudspeakers in locations which might hinder vehicle operations and do
not install in locations with any moisture. Use the installation materials provided with the
loudspeakers.
• Warning! Loudspeakers may produce sound pressure levels that exceed the threshold at
which hearing loss may result. They may also impair a driver’s ability to hear traffic
sounds or emergency vehicles. Practice safe listening when listening to your audio
system. This loudspeakers are developed for motor vehicle use only.
12 month warranty for commercial use and 24 month warranty for private use only. The
location of buying (point of purchase) must be within the EU. The proof of warranty is the
original cashiers receipt with date and type of item on it. The owners manual and installation
instructions must be observed. No warranty of destruction by wrong installation, wrong
operation, non regulated use, using of unsuitable accessories, electrical shocks, fire,
moisture or smoke, damage by improper service and cleaning. Warranty repairs are free of
charge. No refund of shipping costs or labour as well as subsequent damages. Complaints
and repairs do not extend the warranty period.
Environmental Reference
• Old electronic devices don’t belong into the bin.
• If you want to dispose this equipment later, remove all cables
and send it back to Ampire or bring it to a collection point for old
electronic devices.
• You can dispose this device together with your old car, too.
You don’t have to remove it in this case.
• The packing can be recycled. Dispose the packing in a
collecting system planned for it.
3
EN
Electronics – Subject to correction and technical modifications
ampire
2016
Content
2x Woofer
(SP100W or SP130W or SP165W)
2x 19mm Dome Tweeter
2x Woofer Crossover
2x Tweeter Crossover
2x Angeled Top Mounting Cabinet
for Dome Tweeters
2x Speaker Grills
12x Screws
4
Electronics – Subject to correction and technical modifications
ampire
2016
EN
Woofer Installation
Crossover
Ring
Grill
Screws
Woofer
Connect the inputs (the side without terminals) black/white (+) and black (-) of the crossover to
your head unit or amplifier. Be sure of right connections. Then connect the crossover outputs
(the side with terminals) to the woofers terminal and fit the speakers like shown.
To the Radio or Amplifier
mmm
SP130W
SP165W
SP100W
3
EN
Electronics – Subject to correction and technical modifications
ampire
2016
Content
2x Woofer
(SP100W or SP130W or SP165W)
2x 19mm Dome Tweeter
2x Woofer Crossover
2x Tweeter Crossover
2x Angeled Top Mounting Cabinet
for Dome Tweeters
2x Speaker Grills
12x Screws
4
Electronics – Subject to correction and technical modifications
ampire
2016
EN
Woofer Installation
Crossover
Ring
Grill
Screws
Woofer
Connect the inputs (the side without terminals) black/white (+) and black (-) of the crossover to
your head unit or amplifier. Be sure of right connections. Then connect the crossover outputs
(the side with terminals) to the woofers terminal and fit the speakers like shown.
To the Radio or Amplifier
mmm
SP130W
SP165W
SP100W
5
Electronics – Subject to correction and technical modifications
ampire
2016
EN
Tweeter Installation
Choose one of the installation possibilities and install the tweeters like shown. Then connect the inputs
(the side without terminals) black/white (+) and black (-) of the tweeter crossover to your head unit or
amplifier. Be sure of right connections. Then connect the crossover outputs (the side with terminals)
to the tweeter cables. Cut the red loop for -3dB tweeter attenuation.
Attention! After cutting the red loop please cover both wire ends by isolation tape to avoid short
circuits!
In Dash
To the Radio or Amplifier
Tweeter Attenuation
Cut Loop for -3dB
39mm
Top
Dome Tweeter
Crossover
6
Electronics – Subject to correction and technical modifications
ampire
2016
EN
Technical Specifications
Dimensions
Fs / Hz
VAS / L
Qts
Qes
Qms
Re / 
Z / 
Le / mH
SPL / dB
Mms / gr.
Xmax / mm
Sd / cm²
Vd / cm³
D / mm
Pe / Watt
SP100W
87
2,5
0,67
0,88
2,80
3,7
4,0
0,5
88
5,9
4,0
56,7
22,7
85
60 / 120
A
B
C
D
E
SP130W
130mm
118mm
90mm
53mm
5mm
SP165W
165mm
143mm
110mm
61mm
4mm
SP19T
45mm
39mm
26mm
21mm
3mm
SP130W
60
4,5
0,58
0,66
5,27
3,6
4,0
0,5
91
8,1
4,0
95,0
38,0
110
80 / 160
SP165W
54
10,0
0,53
0,60
4,60
3,6
4,0
0,6
91
12,5
6,0
132,7
79,6
130
100 / 200
SP100W
102mm
94mm
70mm
46mm
5mm
A
B
C
D
E
5
Electronics – Subject to correction and technical modifications
ampire
2016
EN
Tweeter Installation
Choose one of the installation possibilities and install the tweeters like shown. Then connect the inputs
(the side without terminals) black/white (+) and black (-) of the tweeter crossover to your head unit or
amplifier. Be sure of right connections. Then connect the crossover outputs (the side with terminals)
to the tweeter cables. Cut the red loop for -3dB tweeter attenuation.
Attention! After cutting the red loop please cover both wire ends by isolation tape to avoid short
circuits!
In Dash
To the Radio or Amplifier
Tweeter Attenuation
Cut Loop for -3dB
39mm
Top
Dome Tweeter
Crossover
6
Electronics – Subject to correction and technical modifications
ampire
2016
EN
Technical Specifications
Dimensions
Fs / Hz
VAS / L
Qts
Qes
Qms
Re / 
Z / 
Le / mH
SPL / dB
Mms / gr.
Xmax / mm
Sd / cm²
Vd / cm³
D / mm
Pe / Watt
SP100W
87
2,5
0,67
0,88
2,80
3,7
4,0
0,5
88
5,9
4,0
56,7
22,7
85
60 / 120
A
B
C
D
E
SP130W
130mm
118mm
90mm
53mm
5mm
SP165W
165mm
143mm
110mm
61mm
4mm
SP19T
45mm
39mm
26mm
21mm
3mm
SP130W
60
4,5
0,58
0,66
5,27
3,6
4,0
0,5
91
8,1
4,0
95,0
38,0
110
80 / 160
SP165W
54
10,0
0,53
0,60
4,60
3,6
4,0
0,6
91
12,5
6,0
132,7
79,6
130
100 / 200
SP100W
102mm
94mm
70mm
46mm
5mm
A
B
C
D
E
SP100
SP130
SP165
ampire
© January 2016 AMPIRE ELECTRONICS. All rights reserved. Reproduction in whole or in part without written permission.
Since its founding in 1987 Ampire Electronics has only one goal, to provide the best possible
Autoalarm-, Autohifi- and Multimedia products, which are available on the international market.
All manufacturing facilities and suppliers are certified according to ISO 9001 and QS-9000.
Ampire quality products are sold worldwide.
An Ampire customer service is available in many countries.
For more information about distributors in your territory please call: + 49-2181-81955-0.
We are focused on future oriented development of user friendly products.
The outstanding high quality standards, functionalities and designs of our products are unique in the
market. "German Development" is taken literally in AMPIRE.
Langwadener Straße 60
D-41516 Grevenbroich
Email: [email protected]
Techical Support:
Phone: 02181-81955-0
Email: [email protected]
www.ampire.de
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7

Ampire SP100 Owner's manual

SP100
Ampire
Brand
Ampire
Model
SP100
Type
Owner's manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents