LADEN WBE3411 A+S AQUA Program Chart

Brand: LADEN

Model: WBE3411 A+S AQUA

Type: Program Chart

This manual is also suitable for

Refrigerator Compartment

1. Fan*

1a. on/off fan button

1b. cover of fan

2. Shelves / Shelf area *

3. Thermostat / light unit

4. Rating plate with commercial name

5. Fruits and vegetables crisper

6. Crisper divider *

7. Doors reversibility kit

8. Door trays

9. Bottle holder *

10. Water tank

11. Egg tray *

12. Door seals

Freezer Compartment

12. Door seals

13. Storage zones for frozen food items

(basket or flap)

13a. ECO GREEN basket for freezing fresh food or to

store frozen food (only in models provided with

ECO GREEN function)

14. Bottom basket for freezing fresh food or to store

frozen food

15. Ice tray*

Anti-bacterial protection:

- Antibacterial filter* in the fan (1)

- Antibacterial additives* in the material of Crisper (5)

- Door seals are made of material able to inhibit

bacterial growth (12)

* Available on selected models

Notes:

- All shelves and door trays are removable.

- The internal temperatures of the appliance may be

affected by the ambient temperature, frequency of

door opening, as well as location of the appliance.

Temperature setting should take into consideration

these factors.

- The appliance accessories are not dishwasher safe.

- After inserting food, ensure that the freezer

compartment door closes properly.

HOW TO INCREASE FREEZER STORAGE

CAPACITY

You can increase storage capacity in the freezer

compartment by:

- removing the baskets and the flap to allow the

storage of big products.

- placing the food products directly on the freezer

shelves.

- the bottom basket is specific compartment for

freezing large food. After inserting food, ensure that

the freezer compartment door closes properly.

HOW TO START THE APPLIANCE

After plugging the appliance to the mains, it starts the

operation automatically.

After starting the appliance, wait at least 4-6 hours

before placing food into the appliance.

Note:

- If food is placed in the refrigerator before the

appliance has cooled completely, it may deteriorate.

FAN

The Fan improves temperature distribution inside the

refrigerator compartment, allowing better preservation

of stored food.

By default, the fan is switched on.

It is advisable to keep the fan switched on when the

ambient air temperature is above 27 ÷ 28°C or if you

notice drops of water on the glass shelves or in sever

humidity conditions.

Please note that when the fan is switched on it will not

continuously work.

The fan will start/stop working depending on the

temperature and/or humidity level inside the fridge. It

is therefore absolutely normal if the fan does not move

even if the fan is switched on. The fan automatically

stops working when the fridge door is open.

Note: Do not obstruct the air intake area with food

items.

To guarantee the right performance at lower ambient

temperature (colder than 18°C) and to minimize

Energy Consumption, turn off the fan.

To turn off the fan press the button of fan (1a).

ANTIBACTERIAL FILTER

(available on selected models)

If the appliance has the Fan it can be equipped with

the antibacterial filter.

Remove it from the box placed in the crisper drawer

(5) and insert into the cover of fan (1b).

The replacement procedure is attached with the filter.

on - o

13a

PRODUCT SHEET

GB FIDKCZBGDEFRNLPL SKRUROPTNOITHUGR UASEES

PRODUCT SHEET

GB FIDKCZBGDEFRNLPL SKRUROPTNOITHUGR UASEES

ECO GREEN FUNCTION (available on selected

models)

This function gives best food preservation

performance with the smallest energy

consumption if there is lower amount of food

to be preserved in the appliance.

The best food preservation conditions when

ECO GREEN function is activated are in the

ECO GREEN compartments:

- 2 “eco green” areas in the fridge (indicated

by green stickers)

- 1 “eco green” basket in freezer

compartment

To select the function turn the ECO GREEN

symbol on the knob of the regulator.

FRIDGE/FREEZER

COMPARTMENT

CONTROLS

A. Thermostat knob

B. Light button

C. Thermostat setting indicator

D. Light bulb

The thermostat adjusts temperature in both

compartments.

Thermostat set to 1/MIN: low cooling intensity

Thermostat set between 1/MIN and 7/MAX : cooling

intensity can be adjusted according to the preferences.

Thermostat set to 7/MAX: maximum refrigeration

intensity.

For the best food conservation 3-5/ MED position is

recommended.

Thermostat set to

•

: cooling and lighting off.

Thermostat set to ECO GREEN : ECO function active.

REPLACING THE LIGHT BULB

Before replacing the bulb, remove the power plug from

the mains socket.

To remove the light bulb turn anticlockwise as shown

in figure.

Check the bulb. If necessary unscrew the broken bulb

and replace it with a traditional bulb (with the same

characteristics of the previous one) or a LED bulb of

the same type available only at our After-sales Service

Centers or authorized dealers.

FREEZING FRESH FOOD

Place the fresh food to be frozen into the bottom

basket.

Avoid direct contact with already frozen food.

DEFROSTING THE REFRIGERATOR

COMPARTMENT

Refrigerator compartment defrosting is completely

automatic.

Droplets of water on the rear wall inside the refrigerator

compartment indicate that the automatic defrost phase

is in progress. The defrost water is automatically run

into a drain hole and collected in a container, where it

evaporates.

DEFROSTING THE FREEZER

COMPARTMENT

The freezer should be defrosted

once or twice a year or when

excessive frost is present (3 mm

thickness).

The formation of frost is normal.

The amount and rate at which frost

accumulates depends on room conditions and how

often the door is open.

To defrost the unit, switch off the whole appliance and

remove all food products.

Leave the freezer door open to allow the frost to melt.

Pull out the defrost water drain and place a container

under the drain (see figure).

When the operation is completed, put back the defrost

water drain.

Clean the inside of the freezer. Rinse and dry

thoroughly. Switch on the appliance and store the food

inside.

CLEANING

Important: Before carrying out any cleaning or

maintenance operation, unplug the appliance or

disconnect it from the power supply.

Regularly clean the appliance using a cloth and a

solution of warm water, with some soft detergent

suitable for cleaning the inside of the refrigerator

compartment.

Do not use abrasive detergents or tools.

To ensure continuous and correct flow of defrost

water, regularly clean the inside of the draining hole on

the back of the refrigerator near the fruit and vegetable

drawer, using the tool provided.

UTILISATION AND MAINTENANCE OF THE WATER DISPENSER AND FILTER

Water dispenser

First use

The first time you use the water dispenser or after a long period left not used wash the tank and the filter with

water.

The water dispenser provides fresh, filtered water, without the need of opening the refrigerator door. This will

reduce the number of times the door is opened, thus also reducing energy consumption of the product.

Fitting and replacing the active carbon filter

The water filter should be removed from the foil bag (found in the crisper drawer (item 5). Follow the instructions

provided with the filter.

Important: If the filter is left dry for an extended period of time, its performance may be reduced. Immerse the

filter in water for a few seconds to reinstate optimum performance.

To ll the tank, rotate the cap in the

direction of the arrow

Tank

Fig.1

Water tank (g. 1)

The water tank is made of antibacterial material. This prevents and reduces

the proliferation of bacteria. An internal container, with an active carbon

ltered ensures water ltration.

To ll the tank: rotate the water inlet towards you and ll with water, using a

jug or other suitable container. Once the tank is full, close the water inlet by

moving it back to its original position.

Always use drinking water only: any other liquid may impair product

performance.

Stop

Activation

device

Water

drip

tray

Fig.2

Obtaining ltered water (g. 2)

After lling the tank, the water may not be immediately available. This is

because the ltering process may require a few minutes (depending on the

amount of water in the tank).

To dispense water: with the refrigerator door closed, press the water

dispenser tab with the glass. If for safety reason water delivery must be

prevented, simply press the stop at the back of the tab. To release water

delivery, move the stop back to its original position. It is recommended to

drink the supplied water from the dispenser in 6 hours.

Fig.3

Cleaning the water tank (g. 3-4-5-6-7-8-9)

Periodically clean the water tank with running water. Twice a year it is

recommended to keep healthy the unit using specic products based

on diluted chlorine that not modify the material properties and rinse with

current water.

To clean the tank, proceed as follows:

- (g. 3) release and remove the upper door tray

Fig.4

- (g. 4) release and remove the water tank by lifting it and pulling towards

you. Place the tank on a at surface, remove and wash the top cover.

Note: the tank must be retted in its position as soon as possible, to

prevent the refrigerator from overheating.

GB FIDKCZBGDEFRNLPL SKRUROPTNOITHUGR UASEES

PRODUCT SHEET

Fig.5

- (g. 5a -5b) remove the internal container and the lter, and wash them

separately.

When washing the lter, only use clean water (no detergent or sharp

tools). To clean the disk lter, rst remove it from the container.

Fig.6 Fig.7

- (g. 6) for a more thorough cleaning, remove the valve cap (the tting

connecting the tank to the refrigerator) by rotating it anticlockwise. Clean

the cap. Important: do not pull on the valve body (g. 7).

Fig.8

- (g. 8) replace the valve cap by rotating clockwise.

Fig.9

- (g. 9) t the tank back in place by placing it between the lateral guides

of the door and pushing it in position, ensuring that the valve is back in its

original seat. Check that the there are no gaps between the rubber seal of

the tank and the door.

Water Filter Duration

To ensure optimum performance you should change the water filter according with the following table:

Water

consumption

(average)

Filter duration

3,0 l/day 4 months

4,5 l/day 3 months

6,0 l/day 2 months

Filter replacement is not covered by product warranty. To order more water filter cartridges, please contact your

after-sales service.

400010731131 Printed 07/14

GB FIDKCZBGDEFRNLPL SKRUROPTNOITHUGR UASEES

PRODUCT SHEET

LADEN WBE3411 A+S AQUA Program Chart

Brand: LADEN

Model: WBE3411 A+S AQUA

Type: Program Chart

This manual is also suitable for

Download PDF

report

LADEN WBE3411 A+S AQUA Program Chart

This manual is also suitable for

LADEN WBE3411 A+S AQUA Program Chart

Related papers

Other documents