2. Industrial & lab equipment
  3. Personal safety & protection
  4. Fire protection
  5. Potter
  6. 70V-1000 Extender for DCA Amplifiers

Potter 70V-1000 Extender for DCA Amplifiers User manual

  • Hello! I've reviewed the installation manual for the Potter 70V-1000 Voltage Extender. This manual provides instructions on how to install and connect the module, which extends the output voltage to 70V for use with DCA-5025 and DCA-10025 devices. It also provides technical specifications and mounting information. I'm ready to answer any questions you have about this device.
  • What is the purpose of the 70V-1000 module?
    How is the 70V-1000 module connected?
    Where should the 70V-1000 module be mounted?
PAGE 1 OF 15409211-REV A 3/21
INSTALLATION MANUAL: 70V-1000 70V EXTENDER
Potter Electric Signal Company, LLC • St. Louis, MO • Phone: 800-325-3936 • www.pottersignal.com
NOTICE TO THE INSTALLER
This manual provides an overview and the installation instructions for the 70V-1000 module. All terminals are power
limited and should be wired in accordance with the requirements of NFPA 70 (NEC) and NFPA 72 (National Fire Alarm
Code). Failure to follow the wiring diagrams in the following pages will cause the system to not operate as intended. For
further information, refer to the control panel installation instructions. The module shall only be installed with listed control
panels. Refer to the control panel installation manual for proper system operation.
1. DESCRIPTION
The 70V-1000 module extends the output voltage to 70V on the DCA-5025 and DCA-10025. The 70V-1000 is equipped
with a stacker bracket for secure mounting.
2. TECHNICAL SPECIFICATIONS
Standby Current 2 mA
Alarm Current 562 mA
70V-1000 Voltage 24VDC
Operating Temperature Range 32° to 120° F (0° to 49°C)
Operating Humidity Range 10% to 93% (non-condensing)
3. INSTALLATION
The 70V-1000 is connected to the DCA-5025 or DCA-10025 using an eight (8) pin ribbon cable. The connection is
supervised and power limited. The 70V-1000 must be mounted in the DCA enclosure. Each card is equipped with bracket
for secure and accessible mounting.
FIguRE 1. 70V-1000 CONNECTION DIAgRAM
firealarmresources.com
/