© 2021 Columbia Lighting, a division of Hubbell Lighting, Inc. Specifications subject to change without notice.
701 Millennium Blvd • Greenville, SC 29607 / Tel 864.678.1000 / Website www.columbialighting.com
Page 1/1 Rev. 11/09/21
COL-CWP-ins
CWP Instruction Manual
CWP
WRAP LUMINAIRE
NOTE: Components shown in images are
representative only and may vary based
on the conguration ordered.
CAUTION
Read instructions carefully and turn electricity o at main circuit breaker panel before beginning installation.
WARNING
If any special control devices are used with this luminaire, follow the instructions carefully to assure full compliance with NEC requirements. If there are any
questions, contact a qualified electrical contractor.
WARNING
This product contains chemicals known to the State of California to cause cancer, birth defects and/or other reproductive harm. Thoroughly wash hands after
installing, handling, cleaning, or otherwise touching this product.
CAUTION
Read instructions carefully and turn electricity o at main circuit breaker panel before beginning installation.
NOTE:
A, D, F & K (shown right) not furnished.
ASSEMBLY STEPS:
1. A D
2. C D
3. E,M F
4. G,B C,D
5. L,H B (snap into place)
6. J B
INSTALLATION INSTRUCTIONS
Drill (2) ⁄" (6.4mm) diameter holes for mounting wood screws.
Wood screws (G) and anchor (C) must be used for securing
back plate (B) to ceiling (D).
/