Astria Fireplaces Eros Multi-View Instruction Sheet

Brand: Astria Fireplaces

Model: Eros Multi-View

Type: Instruction Sheet

GENERAL INFORMATION

SECURE VENT® SQUARE

TERMINATION GUARD KIT

The Secure Vent® square termination guard may be used to cover the

Secure Vent and Secure Flex® square termination to minimize exposure

to the hot surface of the termination.

This kit contains one square termination guard and these instructions.

If you encounter any problems, need clariﬁcation of these instructions or

are not qualiﬁed to properly install this kit, contact you local distributor

or dealer.

Read this instruction sheet in its entirety before beginning the installation.

ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND OPERA-

TION MANUALS PROVIDED WITH THE APPLIANCE APPLY TO THESE

INSTRUCTIONS.

HEARTH PRODUCTS

KITS AND ACCESSORIES

INSTALLATION INSTRUCTIONS FOR SECURE VENT® SQUARE TERMINATION GUARD KIT

(MODEL NO. SV4.5HGS) (CATALOG NO. 87L02) USED WITH DIRECT-VENT GAS FIREPLACES

INSTALLATION INSTRUCTIONS

Step 1. Turn off the ﬁreplace and allow the termination to cool before

proceeding.

Step 2. Position the termination guard over the vent termination as shown

in Figure 1. Ensure that the rear bracket of the termination guard

sits on the top edge of the vent termination base.

Step 3. Secure the termination guard to the exterior wall of the house

using screws (ﬁeld-provided) suitable for the type of wall ﬁnish-

ing material encountered. Use six screws, each driven through a

pilot hole provided in the guard. See Figure 2.

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

Figure 1

Figure 2

750055M

Rev. B 05/2014

WARNING

THIS KIT MUST BE INSTALLED BY A QUALIFIED SERVICE

TECHNICIAN OR OTHER QUALIFIED AGENCY ACCORDING TO

THE MANUFACTURER’S INSTRUCTIONS, ALL CODES AND

REQUIREMENTS OF THE AUTHORITY HAVING JURISDIC-

TION IN THE USA OR CANADA. THE QUALIFIED AGENCY

PERFORMING THIS WORK ASSUMES RESPONSIBILITY FOR

THIS INSTALLATION.

WARNING

THE TERMINATION GUARD PROVIDES A BARRIER TO PREVENT

DIRECT CONTACT WITH THE HOT TERMINATION EXCEPT AT

THE TOP PORTION OF THE TERMINATION GUARD. THIS AREA

IS EXTREMELY HOT DUE TO THE DISCHARGING FLUE GASES.

Termination Guard

Six Screws

(Field-Provided)

TERMINATION GUARD INSTALLATION

Termination guard rear

bracket sits on top edge

of termination

Square Termination

SIDE VIEW OF INSTALLED TERMINATION

GUARD AND TERMINATION

4/15/2014

P/N 750055M REV. B 05/2014

IHP reserves the right to make changes at any time, without notice, in design, materials,

speciﬁcations, prices and also to discontinue colors, styles and products. Consult your local

distributor for ﬁreplace code information.

1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210

Astria Fireplaces Eros Multi-View Instruction Sheet

Astria Fireplaces Eros Multi-View Instruction Sheet

Astria Fireplaces Eros Multi-View Instruction Sheet

Related papers

Other documents