INSTALLATION INSTRUCTIONS
LED FLUSH MOUNT FIXTURE 120VAC/60Hz Input, Dimmable
READ AND FOLLOW SAFETY INFORMATON
CAUTION -Turn off the main power at the circuit breaker before installing and
servicing the fixture to prevent possible injury from electric shock.
All electrical connections must be in accordance with local and National
Electrical Code (N.E.C.) standards. If you are unfamiliar with proper electrical
wiring connections, obtain the services of a qualified electrician.
INSTALLATION & ASSEMBLEY
1. Installing the Crossbar Assembly：Unscrew the mounting screws
from the Crossbar Assembly, remove the Crossbar Assembly from the
fixture body, and keep the mounting screws for later use.Secure the
crossbar assembly to the outlet box (not included) with outlet box screws.
Tighten until snug.
2. Installing the Self-tapping Screw：Using a pencil (not included), mark
the locations on the ceiling that orrespond with the holes on crossbar
assembly.Using a 5/16-inch drill bit (not included), drill pilot holes at
marked locations.For drywall installations, insert wall anchors into the
holes. Otherwise, secure crossbar assembly using self-tapping screws. Then,
fully tighten the outlet box screws.
3.Installing the Lanyard：The lanyard is provided as a means to support
the fixture from the junction box while connecting the electrical wires. This
enables the fixture to hang from the junction box and your hands are free
to make the wire connections.Turn the button stop so it may be inserted
into the crossbar slot. Make sure the button stop is completely inside the
crossbar.Slowly release the fixture to make sure it is supported by the
button stop.Proceed to Step 6. Once wiring is complete, the lanyard will
push into the junction box when the Ceiling Canopy is Attached to the
ceiling.
4.Making the electrical connections：Ground Wire:1. Wrap supply
ground wire around green ground screw on mounting bracket, no less than
2 in. from the end of the wire. Tighten ground screw.2. Connect fixture
green ground wire to supply ground wire with wire connector.
Supply Wire:1. Connect the supply white wire to the white fixture supply
wire with wire connector.2. Connect the supply black (or red) wire to the
black fixture supply wire with wire connector.3. Wrap each connection with
approved electrical tape and carefully stuff all of the connected wires into
the outlet box.
5.Assembling the fixture body to the outlet box：Un-tighten the
Mounting Screws. Do not remove the Mounting Screws.Align
slots on the Fixture Body to Mounting Screws. Place the
Fixture Body to Crossbar Assembly and rotate the Fixture Body
until it is hung safety by Mounting Screws. Tighten Mounting
Screws until snug.
6. Installation complete, restore power at the circuit breaker and
turn light switch on to activate this fixture.
7. This is integrated led fixture, no bulbs to replace
/