Byer of Maine 222P User guide

Lay-out parts as shown below. Leg sets should be placed with rounded (bottom) ends near you and

with the slots for the crossrails facing inward. We provide a straight 4mm hex driver that can be in-

serted in a cordless drill for ease in driving the fasteners.

Place shorter crossrail in slots in inner legs and assemble with 4 screws.

Li outer legs up to expose slots and assemble longer crossrail (with printed

logo up) into slots and assemble with four screws. See images below

Note that fabric sling is tapered on one end. Place the shorter seat rail through that tapered end

and longer seat rail in opposite end. Set frame up on it’s legs and place seat rails on round tenons at the

top of the legs. Insert and tighten the four remaining screws and you’re done.

Parts List:

2 Identical leg sets

2 Lower Crossrails, 1 long, 1 short

2 Seat rails, 1 long, 1 short

12 Assembly screws

1 “L” hex driver

1 Straight hex driver

1 Fabric sling, with one end tapered.

Revised Assembly Instructions --- Byer Pangean Folding Stool

Lower Crossrail (short)

Lower Crossrail LONG, w/Printed Logo

Upper Seat Rails -- 1 long, 1 short

If you have any problem, please

We are here to help you...

e Byer Manufacturing Co.

74 Mill St.

Orono, ME 04473 USA

800-338-0580

comfort@byerofmaine.com