ProSeal 54020 Operating instructions

Brand
ProSeal
Model
54020
Type
Operating instructions

This manual is also suitable for

ProSeal 54020 is a garage door bottom seal kit that helps to seal the gap between the bottom of your garage door and the floor, preventing drafts, pests, and moisture from entering your garage. The kit includes everything you need for installation, including the track, screws, and seal. The seal is made of a durable material that is resistant to wear and tear, and it can be easily trimmed to fit your garage door. The kit also includes a quick tip for installing the seal in soapy water, which makes it easier to slide into the track.

ProSeal 54020 is a garage door bottom seal kit that helps to seal the gap between the bottom of your garage door and the floor, preventing drafts, pests, and moisture from entering your garage. The kit includes everything you need for installation, including the track, screws, and seal. The seal is made of a durable material that is resistant to wear and tear, and it can be easily trimmed to fit your garage door. The kit also includes a quick tip for installing the seal in soapy water, which makes it easier to slide into the track.

4011 Avenida de la Plata Ste. 302, Oceanside, CA 92056 ● www.YourGaragePro.com
(858) 625-0005 ● (800) 992-2018 ● Fax (858) 625-0010 ● Email: [email protected]
54008, 54009, 54016, 54018, 54020
ProSeal
™
Garage Door Bottom Seal Kit
Installation Instructions
1. Remove existing garage door bottom seal, if applicable. Attach track to garage
door bottom by starting at far-left edge of the garage door. Position the track so
it is flush with the outside edge of garage door (edge closest to the street when
the door is closed). Using a power drill/driver, install one screw ½” from the
edge, through the center of the track and into the garage door. Install the next
screw approximately 6” from the previous screw. Continue installing the screws
with the last screw ½” from the opposite edge, of the first track.
2. Next, line up the second track, flush with the first track, so the channels lined up
perfectly. If this is the last track to be installed, before attaching to the garage
door, check to see if you will need to shorten the track. If so, use a hack saw to
cut the track to the desired length, so it is flush with the right side of the garage
door. Install the first screw ½” from the end closet to the first track and continue
installing the screws, as described above. Repeat this process until you have
installed all of the sections of track.
Quick Tip: Mix a bucket of water with some liquid dish soap or liquid laundry
detergent. Place the seal in the soapy water and pull it out as you install it into
the track.
3. Starting at either end of the garage door, insert both of the ¼” T-ends, attached
to seal, into the track. Next, slide the seal into the track, all the way to the
opposite side, so that the seal is protruding 2” beyond the end of the track. Now,
tuck the excess 2” piece of seal, back into the U-shaped opening. This will lock
the seal in place. Finally, trim the opposite side down, leaving 2” protruding and
then tuck it back into the U-shaped opening.
Garage Door Adjustments
For wood garage doors, if the track hits the garage floor or driveway when
closing, adjust the garage door upward, so the track does not hit.
For roll up doors, if the extra thickness of the Garage Door Seal causes the
garage door opener to automatically reopen, adjust the opener at the motor.
  • Page 1 1

ProSeal 54020 Operating instructions

Brand
ProSeal
Model
54020
Type
Operating instructions
This manual is also suitable for

ProSeal 54020 is a garage door bottom seal kit that helps to seal the gap between the bottom of your garage door and the floor, preventing drafts, pests, and moisture from entering your garage. The kit includes everything you need for installation, including the track, screws, and seal. The seal is made of a durable material that is resistant to wear and tear, and it can be easily trimmed to fit your garage door. The kit also includes a quick tip for installing the seal in soapy water, which makes it easier to slide into the track.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI