ProSeal 54016, 54008, 54009, 54018, 54020 Operating instructions

Hello, I'm your chat assistant. I've reviewed the Installation Instructions for the GARAGE PRO ProSeal Garage Door Bottom Seal Kit, models 54008, 54009, 54016, 54018, and 54020. This document details the steps for installing the bottom seal, including track attachment, seal insertion, and adjustments for various door types. Feel free to ask me any questions you have about the installation process or the product itself. I am here to help you with the information available in the provided manual.
How to attach the track to garage door?

How to install the seal into the track?

What to do if the track hits the floor for wood doors?

What to do if the door opener reopens automatically for roll-up doors?

4011 Avenida de la Plata Ste. 302, Oceanside, CA 92056 ● www.YourGaragePro.com

(858) 625-0005 ● (800) 992-2018 ● Fax (858) 625-0010 ● Email: [email protected]

54008, 54009, 54016, 54018, 54020

ProSeal

™

Garage Door Bottom Seal Kit

Installation Instructions

1. Remove existing garage door bottom seal, if applicable. Attach track to garage

door bottom by starting at far-left edge of the garage door. Position the track so

it is flush with the outside edge of garage door (edge closest to the street when

the door is closed). Using a power drill/driver, install one screw ½” from the

edge, through the center of the track and into the garage door. Install the next

screw approximately 6” from the previous screw. Continue installing the screws

with the last screw ½” from the opposite edge, of the first track.

2. Next, line up the second track, flush with the first track, so the channels lined up

perfectly. If this is the last track to be installed, before attaching to the garage

door, check to see if you will need to shorten the track. If so, use a hack saw to

cut the track to the desired length, so it is flush with the right side of the garage

door. Install the first screw ½” from the end closet to the first track and continue

installing the screws, as described above. Repeat this process until you have

installed all of the sections of track.

Quick Tip: Mix a bucket of water with some liquid dish soap or liquid laundry

detergent. Place the seal in the soapy water and pull it out as you install it into

the track.

3. Starting at either end of the garage door, insert both of the ¼” T-ends, attached

to seal, into the track. Next, slide the seal into the track, all the way to the

opposite side, so that the seal is protruding 2” beyond the end of the track. Now,

tuck the excess 2” piece of seal, back into the U-shaped opening. This will lock

the seal in place. Finally, trim the opposite side down, leaving 2” protruding and

then tuck it back into the U-shaped opening.

Garage Door Adjustments

For wood garage doors, if the track hits the garage floor or driveway when

closing, adjust the garage door upward, so the track does not hit.

For roll up doors, if the extra thickness of the Garage Door Seal causes the

garage door opener to automatically reopen, adjust the opener at the motor.