2. Computers & electronics
  3. Computer components
  4. Chassis components
  5. Computer cooling components
  6. Hardware cooling accessories
  7. Arctic
  8. VR002
VR002

Arctic VR002 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Arctic VR002 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Mounting plate x 1
nVIDIA GeForce GTX 285, 280, 275, 260+, 260
Installation of NVIO chipset heatsink
Accessories
Compatibility
Heatsinks x 1Heatsinks x 2Heatsinks x 4Heatsinks x 2Heatsinks x 7Heatsinks x 8
*Be aware that the thermal adhesive comes with a very short shelf life and shall be used within 1 week. We recommend storing the thermal adhesive in a cool area to avoid solidification. Refrigerate after
opening. Additional heatsinks and thermal adhesive are available for purchase at vga.arctic.ac
Do not fasten the screws completely in one step. Fasten each screw alternately (screw A-> D -> B -> C) with 2 to 3 clockwise rotations. Repeat until all 4 screws are tightened.
Thermal pad
Spacer
Adhesive
Tape
X 4
Spacer
Adhesive
Tape
Protective Film
Washers X 4
Screws (M2.5)
X 4
Spacers x 4
& Adhesive Tape
*Thermal adhesive
(3g) x 1
Thermal pad
for NVIO heatsink
(10x 10 x 1mm) x 1
Adhesive Tape x 1
Washers x 4
Spacers x 4Screws (M2.5) x 4Screws (M3) x 2 Screws (M2) x 7
Accessories Set VR002
Installation Manual
For further information, please consult www.arctic.ac
1 2
3
4
5
Tips for applying thermal adhesive
Cure time
RAM
Voltage regulator
Installation of main cooler
Please follow the installation instructions provided with the main cooler.
Installation of RAM and voltage regulator heatsinks
Caution: Please make sure the heatsinks are not touching any circuit components as it may cause a short circuit to your VGA card.
Installation of mounting plate
60mins
How to squeeze out all the glue?
Apply pressure (10 sec)
Heatsinks align to the right Heatsinks align to the left
Heatsinks align to the BottomHeatsinks align to the Bottom
2. Install replacement mounting plate
comes with the accessories set
1. Uninstall default mounting plate
Copyright
2010 ARCTIC Switzerland. All Rights Reserved.
No part of this manual including the products described in it, may be reproduced, transmitted, stored in a retrieval system, or translated into any language in any form or by any means, except documentation kept by the purchaser for backup purposes, without the express written permission of ARCTIC
Switzerland. In no event shall ARCTIC its directors or employees be liable for any indirect damages, incidental or consequential damages arising from any defect or error in this manual or product.
ARCTIC Switzerland
Huobstrasse 4
8808, Pfäffikon, Switzerland
www.arctic.ac
1
2
/