7
• UP/DOWN — Volume is controlled with the UP and DOWN buttons,
with the corresponding LEDs flashing during volume adjustment. If the UP
or DOWN LED doesn’t flash while its volume button is pressed, the level
is at maximum. NOTE: To adjust the volume of individual and pairs of
speakers, use the UP and DOWN buttons in conjunction with the MODE
button (see below).
• STEREO/5.1 CH — Based on the current audio source, press the STEREO
button (CD mode) or the 5.1 CH button (DVD mode) to match the speakers’
output to the system’s input. In the CD mode, the 5.1 CH/STEREO LED
lights red; in the DVD mode (which is also the default), it lights blue.
• MODE — Separate volume control for the subwoofer and the front, rear
and central speakers is available through the use of the MODE button.
Press it once and the SUB LED lights to indicate that the volume of the
subwoofer can now be raised or lowered using the UP and DOWN
buttons. Pressing the MODE button again allows you to cycle through the
CEN, REAR and FRONT LEDs, each corresponding to volume control of
those individual or pairs of speakers when lighted.
• MUTE — Press the MUTE button to interrupt/pause the audio output from
the speakers, indicated by the ST_BY LED flashing red. Press the MUTE
button again to resume audio.
POWER
DOWN
UP
MODE
STEREO
5.1 CH
MUTE
5.1 CH/STEREO
ST_BY
FRONT
REAR
CEN
SUB
UP_LED
DW_LED
IR