2. Munters
  3. Platinum IO Expansion EN R1.1 116766

Munters Platinum IO Expansion EN R1.1 116766 Installation guide

  • Hello! I'm a chat assistant trained to provide information about the Munters I/O Expansion Box. This document is a user manual for the device, and it describes how to connect the expansion box with Platinum Pro, Platinum Touch, or Rotem One controllers. I'm ready to answer your questions about wiring, supported cards, and other aspects of this product.
  • What does the I/O Expansion Box support?
    Do the cards come with the I/O Expansion Unit?
    Where can I find detailed wiring information?
© Munters AB, 2013 P/N: 116766
Ag/MIS/ImEn-2717-04/19 Rev 1.1
I/O Expansion Box for Platinum
Pro, Platinum Touch, Rotem One
The I/O Expansion is an add-on to the Platinum Pro, Platinum Touch, and Rotem One
controllers. I/O Expansion supports three analog input, analog output, and digital input
cards. These cards are wired to their corresponding devices. The controller then
manages the devices.
Figure 1: I/O Expansion Unit
• P/N: 900-16-10003. This is the base part number. Cards are ordered
separately.
• Refer to the Platinum Pro/Rotem Touch/Rotem One Installation manual for
detailed information on wiring the devices to the cards.
© Munters AB, 2013 P/N: 116766
Ag/MIS/ImEn-2717-04/19 Rev 1.1
Layout
Figure 2: I/O Expansion Layout
NOTE The cards shown in Figure 2 are an illustration only. The I/O Expansion supports
any combination of cards.
© Munters AB, 2013 P/N: 116766
Ag/MIS/ImEn-2717-04/19 Rev 1.1
Wiring Diagrams
1. Wire the controller 485ISO-485/PP232ISO-485 card to the I/O Expansion
RS-485 card.
Figure 3: Rotem One to I/O Expansion Wiring / Power cord
© Munters AB, 2013 P/N: 116766
Ag/MIS/ImEn-2717-04/19 Rev 1.1
Figure 4: Platinum Pro to I/O Expansion Wiring / Power cord
2. Wire the device:
o Wire the Digital Input, Analog Input, and Analog Output cards to their
respective devices. Refer to the Platinum Pro Installation manual for
details on the wiring.
o Power:
Connect the power supply wires to the appropriate ports.
110/220 VAC
3. To ensure proper termination, place:
o A terminator on the EXP jumpers on the Platinum Pro communication
card (if the Platinum Pro is located at the end of a daisy chain).
o A 120 ohm resistor on the I/O Expansion communication card (supplied
by Munters).
© Munters AB, 2013 P/N: 116766
Ag/MIS/ImEn-2717-04/19 Rev 1.1
Figure 5: Termination
/