Gigabyte GA-8KNXP Installation guide

Type
Installation guide
Serial ATA(Intel ICH5R).......................................................................2
(1)SATA................................................................................................................2
(2)BIOS SATA...................................3
(3)RAID BIOSRAID...................................................................................5
(4)SATA..............................................8
(5)SATA..........................................................10
Intel ICH5R SATA- 2 -
Ác
Åé
¤¤
¤å
Serial ATA(Intel ICH5R)
SATA
(1)SATA
(2)BIOS SATA
(3)*RAID BIOSRAID
(4)SATA
(5)SATA
(a)SATA(S ATA
RAID)
(b)
(c)Windows XP 2000
(d)
(1)SATA
SATA SATA
SATA(SATA
SATA0_SB/SATA1_SB)
"*"RAID
Intel ICH5R SATA- 3 -
1
(2)BIOS SATA
BIOS SATA
1BIOS POST (Power-On Self Test)<Del>
BIOSCMOS SETUPIntegrated Peripherals
On-Chip SATAAutoManualSATA RAID Function Enabled
(1)RAIDSATA RAID Function Disabled
CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
Integrated Peripherals
On-Chip Primary PCI IDE [Enabled]
On-Chip Secondary PCI IDE [Enabled]
On-Chip SATA [Auto]
xSATA Port0 Configure as SATA Port0
SATA Port1 Configure as SATA Port1
SATA RAID Function [Enabled]
USB Controller [Enabled]
USB 2.0 Controller [Enabled]
USB Keyboard Support [Disabled]
USB Mouse Support [Disabled]
AC97 Audio [Auto]
Onboard H/W SATA [Enabled]
Serial ATA Function [RAID]
Onboard H/W GIGARAID [Enabled]
GigaRAID Function [RAID]
Onboard H/W 1394 [Enabled]
Onboard H/W LAN [Enabled]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Serial Port 2 [2F8/IRQ3]
Item Help
Menu Level }
If a hard disk
controller card is
used, set as Disabled
[Enabled]
Enabled onboard IDE
Port
[Disabled]
Disabled onboard IDE
Port
higf: MoveEnter: Select+/-/PU/PD: ValueF10: SaveESC: Exit F1: General Help
F5: Previous ValuesF6: Fail-Safe DefaultsF7: Optimized Defaults
Intel ICH5R SATA- 4 -
Ác
Åé
¤¤
¤å
2Advanced BIOS Features Hard Disk Boot Priority
Microsoft Windows 2000/XP SATA(2)
2
CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
Hard Disk Boot Priority
1. SCSI-0 : ST3120026AS
2. SCSI-1. : ST3120026AS
3. Bootable Add-in Cards
hi: Move PU/PD/+/-: Change Priority F10: Save ESC: Exit
Item Help
Menu Level }}
Use <h> or <i> to
select a device, then
press <+> to move it
up, or <-> to move it
down the list. Press
<ESC> to exit this
menu.
3
First Boot Device CD-ROMCD-ROM(3)
CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
Advanced BIOS Features
}Hard Disk Boot Priority [Press Enter]
First Boot Device [CDROM]
Second Boot Device [Hard Disk]
Third Boot Device [CDROM]
Password Check [Setup]
Limit CPUID Max. to 3 [Enabled]
DRAM Data Integrity Mode Non-ECC
higf: MoveEnter: Select+/-/PU/PD: ValueF10: SaveESC: Exit F1: General Help
F5: Previous ValuesF6: Fail-Safe DefaultsF7: Optimized Defaults
Item Help
Menu Level }
4
BIOS
3
Intel ICH5R SATA- 5 -
(3)RAID BIOSRAID
SATARAID BIOS SATA RAID
RAID
1BIOS POST (Power-On Self Test)
4<CTRL>+<I>Intel ICH5R RAID BIOS
4
Intel (R) RAID for Serial ATA- RAID BIOS v3.5.0.2568
Copyright (C) 2003 Intel Corporation. All Rights Reserved.
RAID Volumes:
None defined.
Non-RAID Disks:
Port Drive Model Serial # Size Status Bootab
0ST3120026AS 3JT31DJR 111.7GB Normal Yes
1ST3120026AS 3KA0DLZX 111.7GB Normal Yes
Press <CTRL-I> to enter Configuration Utility...
2
<Ctrl>+<I>Intel ICH5R RAID BIOS5
(MAIN MENU): MAIN MENU
1. Create RAID Volume:
2. Delete RAID Volume:
3. Reset Disks to Non-RAID:
4. RAID BIOS
/ (DISK/VOLUME INFORMATION):
5
RAID Volumes:
None defined.
None-RAID Disks:
Port Drive Model Serial # Size Status Bootab
0ST3120026AS 3JT31DJR 111.7GB Normal Yes
1ST3120026AS 3KA0DLZX 111.7GB Normal Yes
[ DISK/VOLUME INFORMATION ]
[ MAIN MENU ]
Intel(R) RAID for Serial ATA-RAID Configuration Utility
Copyright(C) 2003 Intel Corporation. All Rights Reserved. v3.5.0.2568
[hi]- Select [Esc]- Exit [ENTER] -Select Menu
1. Create RAID Volume
2. Delete RAID Volume
3. Reset Disks to Non-RAID
4. Exit
Intel ICH5R SATA- 6 -
Ác
Åé
¤¤
¤å
3(6)
1. Creat RAID Volume <Enter>
(CREATE ARRAY MENU) (
I. (Name): 16
II. (RAID Level): RAID0(Stripe)
RAID0(Stripe)RAID1(Mirror)
III. (Strip Size): RAID0
32K64K
IV. (Create Volume): Cre-
ate Volume<Enter> <Y>
(7)
6
7
Enter a string between 1 and 16 characters in length that can be used
to uniquely identify the RAID volume. This name is case sensitive and
can not contain special characters.
[ HELP ]
[ CREATE ARRAY MENU ]
Intel(R) RAID for Serial ATA-RAID Configuration Utility
Copyright(C) 2003 Intel Corporation. All Rights Reserved. v3.5.0.2568
[hi]- Change [TAB]- Next [ESC] -Previous Menu [ENTER]-Select
RAID_Volume1
RAID0 (Stripe)
128KB
223.5GB
Name:
RAID Level:
Strip Size:
Capacity:
Create Volume
Intel ICH5R SATA- 7 -
(7)DISK/VOLUME INFORMATION
RAID
2. Delect RAID VolumeDELETE RAID ARRAY
<Del> <Esc>
Serial ATA-RAID Configuration Utility<Esc>
7
RAID Volumes:
ID NAME Level Strip Size Status Bootab
0 RAID Volume1 RAID0(Stripe) 64KB 223.5GB Normal Yes
ST3120026AS 3JT31DJR Port0 111.7GB Normal
ST3120026AS 3KA0DLZX Port1 111.7GB Normal
[ DISK/VOLUME INFORMATION ]
[ MAIN MENU ]
Intel(R) RAID for Serial ATA-RAID Configuration Utility
Copyright(C) 2003 Intel Corporation. All Rights Reserved. v3.5.0.2568
[hi]- Select [Esc]- Exit [ENTER] -Select Menu
1. Create RAID Volume
2. Delete RAID Volume
3. Reset Disks to Non-RAID
4. Exit
Intel ICH5R SATA- 8 -
Ác
Åé
¤¤
¤å
(4)SATA
Microsoft Windows 2000/XP SATA
SA TA
SATA
1
2(8)
9
BootDrv
MENU.EXE(9)
8
Intel ICH5R SATA- 9 -
3
MENU.EXE MS-DOS(
10)
11
10
4Microsoft Windows
XP 1 (1)IAA_RAID)SATA
5(11)0SATA
Intel ICH5R SATA- 10 -
Ác
Åé
¤¤
¤å
12
Windows Setup
Press F6 if you need to install a 3rd party SCSI or RAID driver.
(5)SATA
SATA BIOS
Microsoft Windows 2000 XP SATA(Microsoft
Windows XP )
1Microsoft Windows 2000 XP
Press F6 if you need to install a 3rd party SCSI or RAID driver
<F6>(12)<F6>
13 <F6>1
2SATA<S>(13)
13
Windows Setup
S=Specify Additional Device ENTER=Continue F3=Exit
Setup could not determine the type of one or more mass storage devices
installed in your system, or you have chosen to manually specify an adapter.
Currently, Setup will load support for the following mass storage devices(s)
<none>
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
Intel ICH5R SATA- 11 -
3(14)Intel(R)
82801ER SATA RAID Controller<Enter>SATA
14
SATA
4<Enter>SATA1
15
Windows Setup
S=Specify Additional Device Enter=Continue F3=Exit
Setup will load support for the following mass storage device(s):
Intel(R) 82801ER SATA RAID Controller
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
Windows Setup
ENTER=Select F3=Exit
You have chosen to configure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
Intel(R) 82801ER SATA RAID Controller
Intel ICH5R SATA- 12 -
Ác
Åé
¤¤
¤å
SATA(16)<ENTER>
Microsoft Windows 2000 XP
16
WindowsXP Professional
Microsoft(R)
Windows (R) XP
Windows XP
Windows XP
indows XP
ENTER= R= F3=
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

Gigabyte GA-8KNXP Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages