No.14S007-16
4
STC-MC232PCL/STC-MB232PCL
Specifications
Specifications
Electronic specifications / Mechanical specifications / Environmental specifications
*1: Minimum line number on partial scan is 232.
STC-MC232PCL STC-MB232PCL
1/1.8" interline UXGA color 1/1.8" interline UXGA monochrome
progressive CCD: ICX274AQ progressive CCD: ICX274AL
Full scanning, Full scanning,
Partial full scanning, Partial full scanning,
1/2 partial scanning, 1/2 partial scanning,
1/4 partial scanning, 1/4 partial scanning,
Variable partial scanning *1 Variable partial scanning *1
Binning, Binning partial scanning,
Binning 1/2 partial scanning,
Binning 1/4 partial scanning,
Binning variable partial scanning *1
Minimum scene illumination 0.92 Lux at F1.2 0.7 Lux at F1.2
Optical center accuracy
Case
Digital 8 or 10 bit Camera Link (Base configuration)
Edge preset trigger (V-reset, Non-reset), Pulse width trigger (V-reset, Non-reset)
@10bit output
28 (W) x 28 (H) x 46.5 (D) mm (excluding the connector)
Environmental
specifications
4.4 (H) x 4.4 (V) µm
8.5 (H) x 6.8 (V) mm
Progressive
30.63Hz
38.352 kHz
Interface connector
Electronic
specifications
Vertical frequency (Frame rate)
Chip size
<= 15 Digit (Gain 0 dB)
Cell size
Positional accuracy in H and V directions: +/- 0.31 mm
Front, base and rear: Aluminum die cast (ADC12)
Camear Link connector: SDR connector
Gamma
Power 12Vdc via Camera Link connector
Cover: Steel sheet covered with zinc
Rotational accuracy of H and V:+/- 2.1 deg.
UXGA: 1620 (H) x 1236 (V)
2 Taps (The frequency of the clock output at CameraLink: 36.818 MHz)
Scanning system
Horizontal frequency
OFF, 1/9 to 1/240,000 sec. (Variable at every H and clock)
5.1 to 41.8 dB
RS232 via Camera Link connector
EMS: EN61000-6-2, EMI: EN55011 (Class B)
20Hz to 200Hz to 20Hz (5min./cycle), acceleration 10G, 3 directions 30 min. each
1.0
Gain
Lens mount C mount
Less than 4.0 W
Material
Acceleration 70G, half amplitude 6ms, 3 directions 3times each
Mechanical
specifications
IO connector: HR10A-7R-6PB (Hirose) or equivalent