Page is loading ...
For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com
MODEL T32799
DRESSING STONE
INSTRUCTIONS
COPYRIGHT © JULY, 2021 BY GRIZZLY INDUSTRIAL, INC.
NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
(FOR MODELS MFD. SINCE 07/21) #CS21980 PRINTED IN CHINA
Introduction
The Model T32799 Dressing Stone can be used
to clean an aluminum oxide or silicon carbide
stone grinding wheel when it is loaded with metal
filings. The coarse side can also be used to adjust
the grit of the wheel to 220 while the fine side can
be used to adjust the grit to 1000.
V1.07.21
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
Using Dressing Stone
Use the following steps to clean or adjust the grit
of a grinding wheel.
Eye and face injuries and respiratory prob-
lems can occur while operating this tool.
Wear personal protective equipment to
reduce your risk from these hazards.
Keep hair, clothing, and
jewelry away from mov-
ing parts at all times.
Entanglement can result
in death, amputation, or
severe crushing injuries!
Figure 1. Model T32799 Dressing Stone.
Items Needed Qty
Protective Gloves........................................1 Pair
To use dressing stone:
1. DISCONNECT GRINDER FROM POWER!
2. Install desired grinding wheel on grinder.
Coarse-Grained Side
Fine-Grained Side
-2- Model T32799 (Mfd. Since 07/21)
4. Connect grinder to power and turn machine
ON.
5. Carefully place stone against tool rest (if
present) and lower it onto grinding wheel
against wheel rotation (see Figure 5).
— If cleaning 220-grit wheel or changing
grit to 220, place coarse-grained surface
against wheel.
— If cleaning 1000-grit wheel or changing
grit to 1000, place fine-grained surface
against wheel.
6. Press stone against grinding wheel for
approximately 20 seconds or until desired
results are achieved.
7. Turn machine OFF.
Figure 5. Example of Model T32799 in use.
Stone
Tool Rest
Grinding
Wheel
3. Adjust tool rest on grinder as determined by
the set up of your grinder and as described
below:
— For slow-speed grinders like the one
shown in Figure 2, adjust tool rest about
1⁄2" away from grinding wheel so that
when dressing stone is applied, it will be
pressed against wheel rotation.
— For slow-speed and high-speed grinders
like the ones shown in Figures 3–4, adjust
tool rest within 1⁄8" of grinding wheel and so
that when dressing stone is applied, it will
be pressed against wheel rotation.
Figure 2. Example of slow-speed grinder support
tool rest adjusted correctly.
1⁄2" of Clearance
Figure 4. Example of high-speed grinder flat tool
rest adjusted correctly.
1⁄8" of Clearance
Figure 3. Example of slow-speed grinder flat tool
rest adjusted correctly.
1⁄8" of
Clearance
/