DUBAI SOFA
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/dubaisofa
SCAN ME
• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE
www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
1 HOUR
BUILD MAXIMUM
CAPACITY
150Kg
TWO
PERSON
2PC
2PC
12PC
12PC
8PC
Follow us on Instagram
@furniturebox_uk
STEP 1
Use a clean, at, soft surface to avoid any bumps or scratches.
Start by assembling the corner seat unit. Attach the 2x back rest
pieces [B] to the seat [A]. Align the pre-drilled holes. You may nd it
easier to ip the seat and back rests over as shown in the illustration.
Connect using 2 x washers [D] followed by 2x screws [C] on each side
of the back rest pieces - 8 in total. Once all screws are in place, fully
tighten with Allen key [F].
Screw in 4x feet [E].
Flip your corner unit over so it
sits on its feet.
Check stability.
www.furniturebox.co.uk
STEP 2
Assemble the bench unit.
Attach bench back rest [H] to the bench seat [G]. Align the pre-drilled
holes. You may nd it easier to ip the seat and back rests over as
shown in the illustration. Connect using 6x washers [D] followed by
6x screws [C]. Once all screws are in place, fully tighten with Allen key
[F]. Screw in 4x feet [E].
Flip your bench unit over so it sits on its feet. Check stability.
H
Follow us on Instagram
@furniturebox_uk
STEP 3
Add 4x feet [E] to the bottom of the coffee table legs.
Flip your coffee table onto its feet and check stability.
Your sofa set is now ready to use!
www.furniturebox.co.uk
WHAT THE GUARANTEE COVERS
e.g. lose metal threads
e.g. bonding/glue
e.g. legs bending
•
..
e.g. the frame of the
product
ACTIVATE YOUR GUARANTEE ONLINE
scan this QR code with your phone to read
the full guarantee on line and register your
product. It only takes a moment to fill out.
Or visit: furniturebox.co.uour-guarantee
/