TradeQuip Professional 2906T Hydraulic Garage Jack Universal Joint Replacment and Bleed Operating instructions

2906T Hydraulic Garage Jack Universal Joint Replacment and Bleed
TradeQuip Professional
Brand
TradeQuip Professional
Model
2906T Hydraulic Garage Jack Universal Joint Replacment and Bleed
Type
Operating instructions

This manual is also suitable for

MN March22 www.tqbbrands.com.au Page 1 of 2
Hydraulic Garage Jack
Universal Joint Replacment
& Bleed Instructions
Product Code: 2906T
when applying force to the load point.
Universal Joint Release Mechanism Replacement
1. Remove Valve Block Cover.
2. Insert the lower handle half into the handle socket and wind anticlockwise
till the universal joint comes out of the hydraulic block. If the universal is
broken use pliers or multigrips to wind the remaining section from the
hydraulic block.
3. Remove the lower handle from the handle socket and pull the
universal joint out through the handle socket.
4. Replace with the new universal joint and reassemble in the reverse of the steps above.
5. Perform Bleed Procedure (as below) to ensure the Garage Jack has returned to normal operation.
Bleed Procedure
1. Remove the cover panel. Remove the Filler Bung and if required, refill with
ISO46 Grade Hydraulic until the oil is approximately 6mm below the filler
hole then replace the Filler Bung.
The usual symptoms of a Trolley Jack with air in the system are as follows.
- No resistance in the pump stroke while pumping to the load fact [handle feels light].
- Most of the down stroke of the pump handle taken up but no movement of the Lift ram.
-
Pump handle slowly raises on its own while lift arm lowers.
MN March22 www.tqbbrands.com.au Page 2 of 2
2. Rotate the release handle to the raised position.
3. With the help of an assistant stand the jack on its end on the edge of a
bench.
4. While holding the jack by the front axle slowly pump the lift arm out to full
height.
5. With the help of an assistant place jack back onto the floor and tilt on its
front wheels. Rotate the release handle to the lowering position.
6. Ensure the lift arm returns to the fully lowered position.
7. Place jack on the floor and recheck the oil level, Refill to 6mm below the fill port if required before replacing
the filler bung as per step 1.
8. If the issue persists, please repeat steps 2 to 6.
At this point both the Pump and Lift Ram should be free of air and the Jack ready for operation. If the pump still
feels spongy or load is slow to raise, seek the services of a qualified Hydraulic repairer.
The TradeQuip range of Garage Jacks use ISO46 Grade Hydraulic Oil for the correct operation and compatibility with the seals
used in their construction.
  • Page 1 1
  • Page 2 2

TradeQuip Professional 2906T Hydraulic Garage Jack Universal Joint Replacment and Bleed Operating instructions

2906T Hydraulic Garage Jack Universal Joint Replacment and Bleed
TradeQuip Professional
Brand
TradeQuip Professional
Model
2906T Hydraulic Garage Jack Universal Joint Replacment and Bleed
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents