Classic Accessories 78357-SC Operating instructions

• Protects new seats and renews old seats

• 600 denier U.V. resistant fabric is PVC backed for the ultimate in waterproof and

abrasion protection

• Shields against dirt, mud and weather damage

• Hose clean or machine wash

• Elasticized hem and attachment straps provide a custom fit, slips on in seconds

• Bucket cover includes two seat covers and two headrest covers

CAUTION

Be sure that your Seat Covers do not interfere with the controls of your UTV.

Refer to your vehicle operator’s manual for proper instruction on how to remove or tilt your seats

before installation of your cover.

INSTALLATION

Find the tag on the inside of your Seat Covers. This will tell you which side is the front.

Pull the set Cover over the seat back. Then pull the rest of the cover over the seat front. Do the

same with the head rest covers.

For bucket seats:

Find the elastic straps on the back of the cover and attach the plastic hooks together.

For bench seats:

Tighten by attaching the rip-and-grip straps on the bottom of the seat.

78353 & 78357 - Slip your seat cover over the seat and fit your cover as shown below. Install

headrests as that fabric shapes align with your UTV frame.

CLEANING

Clean your Seat Covers with a soft brush and warm water. DO NOT USE SOAP as it can damage

the protective coatings on the fabric. Air dry.

STORAGE

To avoid mildew be sure that your Seat Covers are completely dry before you store them for and

extended period in an enclosed area.

2 Year Warranty - Your seat cover is factory warranted for workmanship and materials for two

years after purchase.

Technical Features & Advantages

78317 (page 2 of 2) 09.27.10