- 2 -
•
2
M965795 (1/17)
3
TEST INSTALLED FITTING
4
SERVICE
• To change direction of handle rotation, proceed as follows:
• Turn valve to OFF position.
• Pull off HANDLE (1).
• Pull off STEM ADAPTER (2).
• Remove SPRING CLIP (4).
• Lift STOP WASHER (3), turn 90˚ and replace.
• Replace SPRING CLIP (4) and STEM ADAPTER (2).
• Reinstall HANDLE (1).
• If spout drips, operate handles several times from OFF to ON
position. Do not force - handles turn only 90˚.
• With HANDLES (1) in OFF position, turn on
WATER SUPPLIES (2) and check all connections
for leaks.
• Remove AERATOR (3).
• Operate both HANDLES (1) to ush water lines thoroughly.
• Rotate SPOUT (5) in both directions.
• Replace AERATOR (3). Direct SPRAY (4) into sink
and activate. Check hose connections for leaks.
WASTE
OUTLET
HOT
COLD
1
3
3a
4
2
Blue Stripe
(C0LD)
Red Stripe (HOT)
1
3
2
1
5
4
2
3
1
90˚
4
MAKE WATER SUPPLY AND WASTE CONNECTIONS
• Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies.
Connection on tting supplies are 3/8" compression.
Connect FLEXIBLE SUPPLY (1) (Marked with a Red Band)
to the Left wall supply and FLEXIBLE SUPPLY (2)
(Marked with a Blue Band) to Right wall supply.
• Connect the VALVE HOSES (3, 3a) to SPOUT TEE (4).
Use adjustable wrench to tighten connections.
Do not over tighten.
• Faucet supplies are 20" long from faucet base.
Note: If additional supply length is required,
installer must purchase additional parts
separately.
Important: If SUPPLY HOSES (1, 2) are to long,
loop as illustrated to avoid kinking.
• Connect 1-1/4" O.D. tail piece on POP-UP DRAIN
to waste outlet.