FMI SDT 220-110 Operating instructions

Step Down Transformer Installation Instructions

Model SDT 220-110

The transformer is factory preset at 220vac. This transformer converts electricity from 220/240 voltage

to 110/120 voltage and will allow the use of a 110/120 voltage appliance in a 220/240 voltage country.

WARNING: To reduce the risk of injury by electric shock, read all instructions.

As with most electrical appliances, electrical parts are electrically live even when

the switch is off.

INSTALLATION

1. Locate electrical power source on the side of replace – refer to owner’s manual of the replace for

correct location.

2. Connect electrical wires (from the electrical junction box of replace) into a three prong plug connector.

3. Plug the three prong connector to the transformer.

4. After all connections are completed, set plug the AC power cord of the transformer into the 220/240

power source.

WARNING: do not plug in any other appliance to this transformer. This trans-

former is dedicated only to the replace. In case of overload, fuse in the trans-

former will be blown. Replace fuse with the same amperage.

Keep this transformer away from water. Do not immerse transformer in water or other liquid. If there is

a humming sound or vibration, disconnect the power cord immediately from the wall outlet and review

instructions to ensure all steps are followed correctly.

126464-01

REV. A

11/12