When the Camera Cable is connected to Main Unit, do not pull
or bend at tight angle.
Pulling on Cable may damage internal wires.
Use the following procedure to attach and remove the Camera
Cable from the Main Unit.
Camera Cable
Connector
Retaining
Ring
Main
Unit
Do Not Pull
Do Not Twist
① Align the ▽ mark on
the connector with the
notch.
TO ATTACH
TO REMOVE
①Rotate the Retaining Ring
to loosen.
②Grip the Retaining Ring
to remove.
NOTICE
Mark
①Align
②Hold the connector
firmly and insert.
③ Screw on the
Retaining Ring to
secure.
Insert
Loosen
Remove
Tighten