Compatibility
Useable on most large format Ink Jet printers using solvent ink systems (Eco-, Light-,
Mild- Solvent inks and similar inks).
Not recommended for printing with oil or water based inks,
Handling
A preconditioning period of 24 hours within the printing environment is
recommended.
Heating system in printer possible up to approx. 48°C. Higher temperature may cause
film deformation.
Between 15-30°C and 30-70% r.h.
Printer set-up: vinyl, coated paper, or similar
Lamination: cold or heat laminates (low-temp) possible but not necessary due to
water-proof prints.
For correct feeding please follow the equipment suppliers manual.
Ink Load: approx. 220 - 280 % (may vary according to ink system).
Avoid fingerprints on printing side.
Storage
Unopened in original packaging storage time is minimum 1 year after shipment
(under recommended storage conditions).
Store in a cool and dry place at a room temperature of 15 - 25°C and at a humidity of
30 - 60%.
Further Articles
Cut sheets
Art. NumberFormatPacking
quantity
04100.000.51000A410
04100.000.44100A450
Folex AG, Bahnhofstrasse 92, CH-6423 Seewen-Schwyz, Tel. +41 41 819 39 39, Fax +41 41 810 01 35
22.12.2010
Update PDFShow online