Page is loading ...
Outside Air Kit – Pellet Stoves and Inserts
99200136
Page 1 of 2 17601029 — 11/26/13 © Travis Industries, Inc.
Packing List
• 1-3/4” Diameter Flex Duct (48” Long)
• Hood with Screen
• Cover Plate
• Air Shutoff Assembly (required only for Canada)
• (3) Hose Clamps
• (2) #8 x 3/8” Screws
• (6) #6 x 1-1/4” Drywall Screws
Compatibility
• AGP Pellet Stove
• AGP Pellet Insert
NOTE: This air kit may be used with earlier Travis pellet stoves. Refer to the manual for air inlet location.
Stove Installation
3/8" Screws
Cover Plate &
1-1/4" screws
1-1/4"
Screws
1-3/4" Diameter Flex Duct
Select a location between framing
members for the outside air hole.
Hood with Screen
Cut a minimum 2" diameter hole in the wall
(use 2" dia. hole saw).
Silicone
Seal the area around the
tube to prevent air from
entering through the wall.
Silicone
3-1/2"
Centerline
5-3/4"
Back of AGP Pellet
Stove
Silicone
Outside Air Kit – Pellet Stoves and Inserts
99200136
Page 2 of 2 17601029 — 11/26/13 © Travis Industries, Inc.
Insert Installation
On pellet inserts the outside air is routed vertically through a blockoff plate (or non-combustible barrier) or
through an ash cleanout. See the installation manual for additional details.
Air Shutoff Assembly
A shutoff assembly is included with this kit for those installations requiring this component (required in
Canada). This component is not required unless local code requires its use.
The appliance will not work with the air shutoff in the closed position.
Installation
The shutoff assembly may be secured to the wall and the air inlet connected with the included hose clamps.
Operation
When in this position,
the air inlet is open.
When in this position,
the air inlet is closed.
/
