ASSEMBLY INSTRUCTION
This page lists all the contents included in the Box. Please take time to identify the
hardware as well as the individual components to this product, As you unpack and
prepare for assembly, plase the contents on a carpeted or padded area to protect
them from damage.
C l e a n i n g & C a r e treat surface with care, Clean surfaces with a dry or damp
sot cloth. Do not use abrasive cleaners. Hardware may loosen over time.
Periodically check that all connections are right.
A philips head screwdriver is nesessary for assembly.
ITEM : 311C473P(3A)
X Base Stool
Please make sure you have all parts before begining assembly. Please wait
until all steps are completed before tightening bolts. We recommend two
people to assemble.
A Phillips head screwdriver is necessary for assembly.
5. Care: Wipe with a damp cloth. Use furniture polish or lemon oil on the
wood as needed. Avoid prolonged exposure to moisture.
4. Not for commercial use.
3. Make sure all bolts and nuts are tightly fastened before the product is used.
2. To avoid damages, assemble this product on a non-abrasive surface such as carpet.
1. Please read the assembly instructions prior to assembling this product.
GENERAL INFORMATION, TIPS & TRICKS
2
Do not put hot pots or objects which are more than
Fahrenheit 80 degrees directly on the table.
3
A. Seat Cushion
QTY: 2 PCS
B. Stool Side
QTY: 4 PCS
C. Stool Top Crossbar
QTY: 4 PCS
D. Stool Bottom Crossbar
QTY: 4 PCS
1. Wood Screw
QTY: 8 PCS
2. Plastic Washer
QTY: 8 PCS
ASSEMBLY INSTRUCTION - STOOL
3. Long Allen Bolt
QTY: 8 PCS
4. Small Wood Dowel
QTY: 8 PCS
QTY: 8 PCS
5.Short Allen Bolt
6. Allen Key
QTY: 1 PC
4
ASSEMBLY INSTRUCTION - STOOL
DIAGRAM #1
a
b
1. Attach two stool top crossbars (C) to two stool sides (B) using four
small wood dowels (4) as instruction (a).
2. Secure the stool top crossbars (C) to the stool sides (B) using four
middle Allen bolts (3) and four plastic washers (2) as instruction
(b). Tighten the Allen bolts with Allen wrench (6).
a
4
2
3
6
5
6
1. Attach two stool bottom crossbar (D) to the stool sides (B) using
four short Allen bolts (5) as instruction (a). Tighten the bolts with
Allen wrench (6).
DIAGRAM #2
B
B
C
a+b
C
a+b
a+b
a+b
D
a
a
a
a
D
B
B
5
Printed in Vietnam
ASSEMBLY INSTRUCTION - STOOL
DIAGRAM #3
a
4. Place the seat cushion (A) upside down on a non-abrasive surface
such as carpet. Attach the stool base to the seat cushion (A) using
four wood screws (1) as instruction (a).
5. Turn the stool upright. The stool is now ready for use.
6. Repeat Diagram #1 to #4 to assembly the second stool.
DIAGRAM #4
1
a
a
a
a
C
A
C
/
