Place fresh
batteries in
the remote
control.
NOTE: To ensure safe operation
please follow the Battery Installation
precautions in your owner’s manual.
NOTE: If you receive Satellite or Cable service
through a set top box, tune to the correct input
on your HDTV and use the receiver and its
remote for channel viewing.
NOTE: Before proceeding, make sure your
antenna and equipment are hooked up
correctly to the HDTV.
Plug in the HDTV and
any other AV equipment
hooked up to your HDTV.
Handle the HDTV by the cabinet
only, do not touch the screen
Place the HDTV on a flat firm
surface and allow adequate space
on both sides, top, and back.
You may acces an On Screen
Help menu with common
problems and solutions by
pressing the VOL key.
Turn on your HDTV and all
of the AV equipment that is
hooked up to it.
Press CH▲ or CH▼ to perform
a channel search from an
Antenna or a direct Cable
connection
Press CH▼ if you’re setting
up your TV for home use.
OR
Press CH▲, if the TV set will
be put on display.
The screen can be damaged if it’s not maintained
properly. Do not use hard objects such as hard
cloth or paper.
Do not use excessive pressure when cleaning the
screen; excessive pressure can cause permanent
discoloration or dark spots.
NEVER spray liquids on the screen!
You may acces an On Screen
Help menu with common
problems and solutions by
pressing the VOL key.
Handle the HDTV by the cabinet
only, do not touch the screen
Please be sure to:
Please be sure to:
Place the HDTV on a flat firm
surface and allow adequate space
on both sides, top, and back.
Please save the carton
and all packaging
material in case return
or repair is needed.
HDTV INITIAL SETUP
ETHERNET (LAN) CONNECTION
PROTECTING YOUR HDTV’s SCREEN
Need
help?
Visit our website
www.sanyoctv.com
Call toll free
1.877.864.9604
One of our Service
associates will be
glad to assist you!
HDMI, the HDMI Logo and High-Definition Multimedia Interface
are trademarks or registered trademarks of HDMI Licensing LLC
in the United States and other countries.
Sanyo Manufacturing Corp.
3333 Sanyo Road, Forrest City, AR 72335
Si necesita ayuda en ESPAÑOL, marque
al 1-877-864-9604 y nuestros asesores
estarán dispuestos a ofrecerle ayuda
con cualquiera de sus dudas.
High quality pictrue is available with proper HD signal and connection.
Please wait while your TV searches for channles and Signals.
Digital 000 Analog 000
Please select the proper location for your TV,
the display will be adjusted for best results
Store mode is for the retail display setup.
Home mode qualifies for ENERGY STAR
Press CHannel UP for Store Mode.
Press CHannel DOWN for Home Mode.
Please connect all antennas* and signals to the jacks and terminals.
Make sure all of your equipment is switched on.
*
To avoid signal interference when searching for channels using
an Indoor Antenna, place the antenna at least 3 feet away from TV./
Press CHannel UP or DOWN for Channel/Signal search.
Press VOLume DOWN for On Screen Help.
1
2
3 5
6
4
Turn on your HDTV and all
of the AV equipment that is
hooked up to it.
Press CH▲ or CH▼ to perform
a channel search from an
Antenna or a direct Cable
connection
Press CH▼ if you’re setting
up your TV for home use.
OR
Press CH▲, if the TV set will
be put on display.
After the Channel/Signal search
process is completed, tune to the
desired input by pressing the INPUT
key on your remote.
After the Channel/Signal search
process is completed, tune to the
desired input by pressing the INPUT
key on your remote.
The screen can be damaged if it’s not maintained
properly. Do not use hard objects such as hard
cloth or paper.
Do not use excessive pressure when cleaning the
screen; excessive pressure can cause permanent
discoloration or dark spots.
NEVER spray liquids on the screen!
Enable your HDTV’s Internet features by hooking up your HDTV to your local
Network: Use the supplied USB WiFi dongle for a wireless connection to
your wireless Modem or Router. An Ethernet cable may be used for a wired
connection from your HDTV’s ETHERNET port to a Router or Modem.
NOTES: Ethernet cable colors are for reference only.
Actual hookup from Internet Service Provider to Modem/Router may vary.
Network
Wired
Wireless
Setting Mode
Connect Test
Use the Network menu options on your HDTV
to setup and verify your HDTV’s connection to
the LAN (Local Area Network.)
Wired is for a LAN setup using an Ethernet cable.
Wireless is for a LAN setup using a WiFi USB
dongle (supplied) and a wireless Modem or Router.
B
C
B
C
Refer to the Internet-Ready HDTV
Guide for more information.
Refer to the Internet-Ready HDTV
Guide for more information.
A
A
A
1
2
Sanyo DP42849 - 42" LCD TV Setup Manual
Sanyo NET@ DP47460 Network Manual
RCA scenium User manual
Infocus 61md10 User manual
HP (Hewlett-Packard) Home Theater System 2307890A User manual
Haier LE32N1620 Owner's manual
Vizio SV472XVT User manual