2
01
1. To reduce the risk of electric shock, ensure the electricity
has been turned off at the circuit breaker or fuse box
before you begin.
2. All wiring must be in accordance with the National Electrical
Code ANSI/NFPA 70-1999 and local electrical codes.
Electrical installation should be performed by a qualified
licensed electrician.
3. The outlet box and support structure must be securely
mounted and capable of reliably supporting 35 lbs. (15.9 kg).
Use only UL Listed outlet boxes marked
“Acceptable for Fan Support of 35 lbs. (15.9 kg) or less”.
4. The fan must be mounted with a minimum of 7 ft. (2.1 m)
clearance from the trailing edge of the blades to the floor.
5. Do not operate the reversing switch while the fan blades
are in motion. You must turn the fan off and stop the blades
before you reverse the blade direction.
6. Do not place objects in the path of the blades.
7. To avoid personal injury or damage to the fan and other
items, use caution when working around or cleaning the fan.
8.Electrical diagrams are for reference only. Light kits that
are not packed with the fan must be Ul-listed and marked
suitable for use with the model fan you are installing.
Switches must be UL General Use Switches.
Refer to the instructions packaged with the light kits and
switches for proper assembly.
9. After making electrical connections, spliced conductors
should be turned upward and pushed carefully up into the
outlet box. The wires should be spread apart with the
grounded conductor and the equipment-grounding conductor
on one side of the outlet box.
10. All setscrews must be checked and re-tightened where
necessary before installation.
WARNING: To reduce the risk of personal injury,
do not bend the blade brackets (also referred to as
flanges) during assembly or after installation. Do not
insert objects in the path of the blades.
WARNING: To reduce the risk of fire or electric shock,
this fan is NOT suitable for use with solid-state speed
controls.
WARNING: To avoid possible electrical shock, make
sure that the electricity is turned off at the main power
box before starting work. If you feel you do not have
enough electrical wiring knowledge or experience,
contact a licensed electrician.
WARNING: Electrical diagrams are for reference only.
Optional use of any light kit shall be UL-listed and
marked suitable for use with this fan
WARNING: To reduce the risk of fire, electrical shock
or personal injury, ensure that the fan mounting
bracket is supported directly from the building
structure or the outlet box marked “Acceptable for
Fan Support of 35 lbs. (15.9 kg) or less”. Use only
the screws provided with the outlet box.