info@hamiltonsinkler.com
www.hamiltonsinkler.com
Tel: 212-760-3377
1 of 1
Accessories
Floor Stop Installation & Template
1. Remove Cap on door stop
2. Place door stop into position and mark where hole is to be drilled
3. Drill 5/16” hole either a pilot hole if wooden oor or a hole big enough to house anchor (insert anchor) in concrete oor
Be cautious not to drill into under oor heating systems
4. Place door stop over hole and secure with screw
5. Screw on cap should now be inserted
13
8
"
15
8
"
11
2
"
2"
SCREW ON CAP
FASTENER/SCREW
RUBBER BUMPER
DOOR STOP BASE
PLASTIC ANCHOR (for wood or concrete)
(NOT SUPPLIED)
AC84
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI