The KitchenAid KHRT 6010/I glass ceramic hob is designed for versatile cooking and easy cleanup. With its four cooking zones, you can boil, simmer, fry, and more, all at the same time. The residual heat indicators let you know which zones are still hot, and the child lock prevents unintended activation for added safety.
The KitchenAid KHRT 6010/I glass ceramic hob is designed for versatile cooking and easy cleanup. With its four cooking zones, you can boil, simmer, fry, and more, all at the same time. The residual heat indicators let you know which zones are still hot, and the child lock prevents unintended activation for added safety.
KHRT 6010/I
KHRT 7710/I
Instructions for use
501971902072_GB 12-11-2007 11:14 Pagina 1
501971902072_GB 12-11-2007 11:14 Pagina 2
Before using the glass ceramic hob 4
Installation 4
Electrical connections 6
Energy saving tips 7
Safeguarding the environment 7
Precautions and general recommendations 8
Hob accessories 9
Care and maintenance of the glass ceramic hob 9
Troubleshooting guide 10
After Sales Service 10
501971902072_GB 12-11-2007 11:14 Pagina 3
• To make the most of your new appliance, please read the user instructions carefully and keep them
handy for future consultation.
Before using the glass ceramic hob
Hob
• The Hob has to be set into a worktop between 20 – 50mm
deep.
• Do not place any material between the cooktop and oven
(cross beams, brackets, etc.)
• The distance between the lower face of the glass ceramic
hob and the cupboard or separating panel must comply
with the sizes shown in figure “A”.
• If a column cabinetry unit has to be installed next to the
cooktop, leave a distance of at least 100mm from the edge
of the cooktop.
Cut out the hole in the work surface to the dimensions shown in
the enclosed description sheet.
Clean the work surface, then apply the gasket around the
underneath of the hob (unless it has already been installed).
Important
In order to prevent the electronic circuits overheating and becoming
damaged, we recommend the following:
• Do not install the hob near a dishwasher, or washing
machine as steam or moisture could damage the electronic
controls.
If an oven is installed beneath the cook top (from our range of
ovens), make sure it is equipped with a cooling system.
If the temperature of the electronic circuits exceeds the maximum
permitted temperature, the hob will automatically switch off; if this
happens, wait a few minutes until the electronic circuits cool down,
at which point it will be possible to turn the hob on again.
• Turn the hob off after use.
Installation
4
Front
Rear wall
501971902072_GB 12-11-2007 11:14 Pagina 4
Installation
A) If the work top is made of wood, use the appropriate brackets,
spring clips and screws provided.
• Position the 4 clips (A) around the cooktop frame, in the slots
provided. See Fig. 1.
• Measure the centre of the vertical sides of the cut-out as shown in
Fig. 2.
• Position the centre of the brackets (C) on the centre of the side
previously identified.
• The upper edge of the brackets must be flush with the work top
surface.
• Secure using the 4 screws (B) provided that should screw into the
pre-prepared holes.Insert the hob in the pre-prepared hole so
that the clips (A) lodge into the bracket holes provided (C Fig. 4
and 5).
B) If the work top is made of marble or other materials
(plastic, ceramic tile, stone etc.), the cooktop must be fitted
with code no. 4819 310 1852 brackets (to be ordered from the
Customer Care Department).
• Fit the cooktop into the worktop.
• Use the brackets (C) by positioning them as shown in the diagram
according to the thickness of the worktop.
• Tighten the screws (E) into the holes (D).
Installation
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
5
Top min. 20
Top max. 50
501971902072_GB 12-11-2007 11:14 Pagina 5
The electrical connection must be made before connecting the
appliance to the power supply. The apparatus must be installed by a
qualified electrician who is fully aware of current safety and installation
regulations. The installation must be carried out in compliance with
regulations of the local electricity company. Make sure that the voltage
shown on the rating plate is the same as the power supply voltage in
your home. Regulations require that the apparatus be earthed: use
conductors of the appropriate size only (including the earth conductor).
The manufacturer declines all responsibility for injury to persons or
animals and for damage to property resulting from failure to observe
the above regulations. For the electrical connection, use a H05 RR-F
cable as indicated in the table below:
Power supply voltage
Conductors Amount per measurement
230V ~ + 3 X2,5 mm
2
230-240V ~ + 3 X2,5 mm
2
(Australia only)
230V 3~ + 4 X 1,5 mm
2
400V 3N ~ + 5 X1,5 mm
2
400V 2N ~ + 4 X1,5 mm
2
The appliance must be connected to the electricity supply by
means of a multi-pin disconnecting switch with a minimum
contact gap of 3mm.
Warning: the power supply cable must be long enough to allow the
cooktop to be removed from the worktop and must be positioned so
as to avoid damage or overheating caused by contact with the base.
Connecting to the terminal board
Note: the yellow/green earth wire must be connected to the terminal
with the symbol and must be longer than the other cables.
• Remove approx. 70mm of cable sheath from the power supply cable
(B).
• Strip approx. 10mm of sheath from the wires. Then insert the
power supply cable into the cable clamp and connect the wires to
the terminal board as indicated in the connection diagram near the
terminal board itself.
• Secure the power supply cable (B) using the cable clamp.
• Close the terminal board with the cover (A), using the screws
provided.
• After completing the electrical connection, fit from the top and hook
it to the support springs as illustrated.
Electrical connections
6
501971902072_GB 12-11-2007 11:14 Pagina 6
• Use pans with a diameter equal to that of the cooking zone.
• Only use flat bottom pans.
• If possible use pan lids whilst cooking.
• Cook vegetables, potatoes etc, using minimum water to keep
down cooking times.
• A pressure cooker allows you to save even more energy and time.
Energy saving tips
1. Packing
• The packing material can be 100% recycled as confirmed by the recycling symbol ( ).
2. Products
• This appliance is marked according to the European Directive 2002/96/EC, Waste Electrical and
Electronic Equipment (WEEE). By ensuring that this product is disposed of correctly, you will help
prevent potentially negative consequences for the environment and human health.
The symbol on the product or on the documents accompanying the product indicates that this
appliance may not be treated as household waste. Instead, it should be handed over to the applicable
collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in
accordance with local environmental regulations for waste disposal. For more detailed information on
treatment, recovery and recycling of this product, contact your local authority, the household waste
disposal service or the shop where you purchased the product.
Declaration of CE conformity
• These appliances are designed to come into contact with food stuffs and are constructed in compliance
with EEC (CE) Regulation n. 1935/2004.
• The appliances were designed solely for use as cooking appliances.
• Any other use of the appliances (e.g. heating rooms) is considered as improper use and potentially
dangerous.
• The appliances were designed, built and sold in compliance with:
• safety objectives of the “Low Voltage” Directive 2006/95/CE (which replaces 73/23/CEE and
subsequent amendments).
• the protection requirements in Directive 89/336/CEE on “Electromagnetic Compatibility”.
• the requirements of Directive 93/68/EEC.
Safeguarding the environment
7
NO!
501971902072_GB 12-11-2007 11:15 Pagina 7
IMPORTANT : The accessible parts on the appliance become extremely hot when in use. Keep
children away from the appliance to prevent the risk of burning or scalding.
Make sure children do not play with the appliance.
• Warning: this is a heavy products which requires the installation to be carried out by two
people.
• This appliance is not intended for use by persons (including children) with reduced physical, sensor or
mental capabilities or lack of experience and knowledge unless they have been given initial supervision
or instruction concerning use of the applaince by a person responsible for their safety.
• Before doing any maintenance work on the appliance, disconnect it from the electrical power supply.
• Keep children away from the appliance whilst it is in use and whilst it is cooling down.
• The appliances should only be repaired or adjusted by a qualified electrician.
• Make sure the electrical wires of other electrical appliances do not come into contact with hot parts.
• Do not switch on the hot plates/cooking area when there is no pan in position.
• Avoid the use of steam cleaning equipment.
• If liquids spill, or boil over the hob may switch off. Before the hob will reactivate, the control panel area
must be carefully dried.
• Different size rings/cooktops are fitted on the hob. Use pots with the same base diameter as the ring /
cooktop.
• To avoid permanently damaging the glass ceramic hob, do not use:
- pans with bottoms that are not perfectly flat
- metal pans with enamel bottoms.
• When finished cooking, press the button .
• Do not use the cooktop as a work or support surface.
• Do not leave the appliance unattended when frying – fire risk.
• If the glass ceramic surface should break or crack due to a violent impact (falling objects etc.),
disconnect the appliance from the electrical power supply and contact the Customer Care Centre
immediately.
• Do not place food wrapped in aluminium foil, plastic containers or cloth on the hot cooking areas.
• Do not drag pans across the glass ceramic surface – risk of scratching.
• Avoid spilling sugar or other substances on the surface. If this happens clean the surface immediately as
the sugar solution may 'etch' into the surface.
• Never heat a tin, or can with food in it as the tin or can may explode.
Precautions and general recommendations
8
501971902072_GB 12-11-2007 11:15 Pagina 8
Child guard accessory AMH 122
This accessory can be obtained from the Customer Care Centre
under Part No. 4819 310 18436.
Hob accessories
Clean the cooking area after use, when cool. This will prevent the
build up of dirt and make cleaning easier.
Important: Avoid the use of steam cleaning equipment.
• Use a clean cloth, kitchen roll and washing up liquid, or a ceramic
glass cleaner.
• Remove stubborn dirt with the scraper supplied.
• Food spills should be cleaned off the ceramic surface before they
turn hard.
• Foods with high sugar content (toffee, fruit juice, marmalade, etc.)
that boil over while cooking or spattered sugar stains resulting
from cooking should be removed immediately using the scraper,
or they will 'etch' into the ceramic surface.
• Do not use abrasive products, bleach, oven cleaner sprays or pan
scourers.
The glass ceramic hob should be periodically treated with proprietary
brand of wax.
Care and maintenance of the glass ceramic hob
9
501971902072_GB 12-11-2007 11:15 Pagina 9
Hob not working
• When pressing the control buttons, follow the instructions in the section “Using the hob” in the
enclosed “Product Description Sheet”.
• Is there a power failure?
• Did you dry the hob carefully after cleaning it?
1. If a ring has been selected and an “F” or “ER” appears on the display followed by a number,
contact the Customer care centre.
With the exception of the message “F03” or “ER03” that signals the incorrect cleaning of the
controls area.
To solve the problem, follow the instructions in the paragraph on “Cleaning and maintenance of the
glass ceramic hob”.
2. If one of the following codes appears when you press the ignition button on the hob: F12, F13, F22,
F25, F31, F36, F47, E2, E5, E6, E7, E9, contact the Customer Care Centre and tell them which code
appears.
3. If the hob does not work after intensive use, it means that the temperature inside the hob is too high.
Wait for a few minutes until the hob cools down. The display shows the “F21” code.
Important!
If you cannot turn off the ceramic hob after use, unplug the appliance from the electricity supply
immediately and call the Customer Care Centre.
Troubleshooting guide
10
Before contacting the Customer Care Centre
1. Check the "Troubleshooting guide" to see if the problem can be
resolved quickly.
2. Turn off the appliance and switch back on to see if the fault is
repeated.
If after carrying out the above checks, the fault persists, contact the
Customer Care Centre.
Please give:
• a short description of the fault;
• the precise type and model of the hob;
• the service number (the number after the word Service on the
date plate), located under the hob. The service number can also
be found in the warranty booklet;
- your full address;
- your telephone number.
Note: failure to comply with these instructions could seriously
compromise the safety and quality of the hob.
After Sales Service
501971902072_GB 12-11-2007 11:15 Pagina 10
501971902072_GB 12-11-2007 11:15 Pagina 11
5019 719 02072
Printed in Italy
n
11/07
GB
Whirlpool Europe S.r.l.
Viale G. Borghi, 27 - 21025 Comerio (VA)
Phone 0332.759111 - Fax 0332.759268
www.whirlpool.eu
501971902072_GB 12-11-2007 11:15 Pagina 12
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
The KitchenAid KHRT 6010/I glass ceramic hob is designed for versatile cooking and easy cleanup. With its four cooking zones, you can boil, simmer, fry, and more, all at the same time. The residual heat indicators let you know which zones are still hot, and the child lock prevents unintended activation for added safety.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Whirlpool AKT 808/NE User guide
-
Whirlpool AKT 8210/NE Owner's manual
-
Whirlpool ETPS 6740 IN User guide
-
Whirlpool AKT 820/NE User guide
-
Whirlpool AKT 842/BA User guide
-
Whirlpool ELIE 6160 IN Installation guide
-
-
-
Whirlpool AKP 364 IX Installation guide
-
LADEN PRS 300/NE User guide