INSTALLATION INSTRUCTIONS
Item #N6960-1 (Rev. 11/25/2015)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
HANGING THE FIXTURE (Fig. 1)
1. Carefully remove the fixture from the carton
and check that all parts are included as
shown in the illustration.
2. Shut off power at the circuit breaker and
remove old fixture including the mounting
hardware.
3. Attach the Mounting Plate (A) to the Outlet
Box using the two screws (B). The side of the
mounting Plate marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
4. At this point, connect the electrical wire as
shown in figure 2, making sure that all wire
connectors are secured. If your outlet has a
ground wire (green or bare copper), connect
the fixtures Ground Wire to it. Otherwise,
connect the fixture Ground Wire directly to the
reinforcement plate using the Green Screw
provided.
FINISHING THE INTALLATION (Fig. 1)
5. Place Canopy (C) over the Mounting Plate (A)
and secure with Screws (D) by the Allen
Wrench (E) provided.
6. Install the light bulbs (not included) in
accordance with the fixture’s specifications.
(DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!) (NE PAS DEPASSER
LA PUISSANCE NOMINALE MAXIMALE!)
7. Place the Nipple (F) to the bottom of Fixture
Body, then place Glass Shade (G) over the
Nipple and secure in place with Finial (H).
Your installation is now complete. Return
power to the junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is
for installation purposes only. It may or
may not be identical to the fixture
purchased.
FIXTURE
WIRES
Black or
Smooth
H
O
USE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
H
O
USE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
H
O
USE
WIRES
Green
(Ground)
LA-1668E
D
E
H
G
F
C
A
B
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI