Q
19.50
CARD-58 CAP
ANCHOR
DRILLED
HOLE
THREAD
INSERT
SCREW
Step 1:
Determine your desired location for installation and make a mark for the location . Make 2 marks where mounting screws will
be placed as shown below. Make sure shelf is level when marking for location of installation.Drill hole at each end of the
marks.
Drill holes in Wall for screw anchors
Attach Shelf to mounting Surface.
Step 2:
RC-1-22TB
INSTALLATION INSTRUCTIONS
No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.
-
1
Allied Brass RC-1/22TB-ORB Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI