7
6
1
2
7
5
3
4
9
8
0
Remote Control
1
Power Button
Turns the remote control power ON and
OFF.
Pushing the POWER button while the
chair is activated causes the rollers
to return to the starting position, after
which the chair turns itself off .
When the power of the remote control is
OFF, the button ashes in blue. When
the power is ON, the button lights in
blue.
2
Pause Button
Press this button when you want to
pause a massage.
During a pause, the Power button and
the Pause button ash alternately in
blue and red, respectively.
When the Pause button is pressed
again, the massage starts again from
the point it was paused.
When the Power button is pressed, the
massage ends.
3
Heat Button
The hand and sole heaters can be
switched ON/OFF.
When the heater is on, the button lights
in red.
When a quick session has been chosen,
the heater is ON.
4
Massage Intensity
Buttons
The intensity of an upper body massage
can be adjusted in 3 levels.
When the massage intensity is Low,
Medium, or High, the buttons light
green, orange, or red, respectively.
5
Air Intensity
Buttons
The intensity of an air massage can be
adjusted in 3 levels.
When the air intensity is Low, Medium,
or High, the buttons light green, orange,
or red, respectively.
6
Pre-Programmed
Massage
Sessions
The desired session can be selected.
The selected session button lights in
white.
7
Massage Position
Adjustment
Buttons
These buttons are used to adjust the
shoulder positions during shiatsu point
location or the position of the rollers
during a manual session.
During shiatsu point location, the up/
down buttons ash in white alternately.
8
Chair Recline
Button
The reclining angle can be adjusted.
The operating button lights in white.
Furthermore, the functioning button
lights in white even when the reclining
angle is changed automatically during a
session.
9
Footrest Button
The angle of the footrest can be
adjusted.
The operating button lights in white.
Furthermore, the functioning button
lights in white even when the footrest
angle is changed automatically during a
session.
0
Manual Functions
The desired session can be selected.
The selected session button lights in
white.
* For an explanation of each session, see pages 15 and 16.
[NAMES OF PARTS & FUNCTIONS]
Warning
z
Do not spill water or other liquids on the
remote control.
z
Do not handle the remote control with wet
hands.
Caution
z
Do not sit, step or place heavy objects on the
remote control.
z
Do not drop the remote control. It is
recommended that the remote control be
placed in the remote control pocket when not
in use.
z
Do not exert excessive force on the remote
control.
z
Do not pull the remote control cord forcibly.
z
Do not operate the remote control using
sharp-edged or hard objects. It may result in
damage.