Marshall Electronics LCD Rack Mounted Monitor V-R151P User manual

Marshall Electronics
Brand
Marshall Electronics
Model
LCD Rack Mounted Monitor V-R151P
Category
LCD TVs
Type
User manual
Desk Stand
VP-LCD171H-ST-01
Use for Desk Top Applications
Wall Mount V-LCD17-TV-WM Attaches monitor to Wall
Ceiling Mount V-LCD17-TV-CM Attaches monitor to ceiling
Power Adapter Cable V-PAC-D Use with Anton Bauer D-type connection
Power Adapter Cable V-PAC-XLR Use with Anton Bauer D-type connection
Sequential
2 channel charger
IDX-VL-2Plus Combination unit is a 2-channel sequential charger with a built-in
60W power supply. Charges 2 ENDURA E series batteries in fewer
than 5 hours. One 10’ XLR cable included.
Sequential
4 channel charger
IDX-VL-4 Economically charges 4 ENDURA E series batteries in under 6
hours using Full Power Charge (FPC) method
Simultaneous
4 channel charger
IDX-VL-4S
Charges 4 ENDURA E series batteries in 2.5 hours or less.
55 W Lithium Battery
IDX-E7S
V-Mount battery pack with 3 LED power Indicator
55 W Lithium Battery
with Power Link
IDX-E7 V-Mount Battery Pack with PowerLink includes accurate Power
Status Display and supports Digi-View
82 W Lithium Battery IDX-E10S V-Mount battery pack with 3 LED power Indicator.
82 W Lithium Battery
with Power Link
IDX-E10
V-Mount Battery Pack with PowerLink includes accurate Power
Status Display and supports Digi-View
Battery Adapter V-DV-PWR1
Uses 2 Sony DVCam/HDV FP-Type batteries.
When used with monitor power supply, can charge batteries plus
operate monitor
Digital to Analog
Converter
BC-301-08/10 Converts SDI/HDSDI to analog Composite, YC, or Component video
Cleaning Wipes V-HWP-K Converts SDI/HDSDI to analog Composite, YC, or Component video
Marshall Electronics
1910 East Maple Ave.
El Segundo, CA 90245
Tel.: 800-800-6608 • 310-333-0606
Fax: 310-333-0688
www.LCDRacks.com
Email: [email protected]
Marshall Electronics warranties to the first consumer, that this V-R151P 15 inch LCD rack mounted monitor will, under normal use, be free from defects in workmanship and materials, when
received in its original container, for a period of one year from the purchase date.
This warranty is extended to the purchasing end user only and proof of purchase is necessary to honor the warranty. If there is no proof of purchase provided with a warranty claim, Marshall
Electronics reserves the right not to honor the warranty set forth above. Therefore, labor and parts may be charged to you.
This warranty does not apply to product exterior and cosmetics. Misuse, abnormal service or handling, improper alterations or modifications in design or construction, voids this warranty. No
sales personnel of the seller, nor any other person is authorized to make any warranties other than those described above, or to extend the duration of any warranties on behalf of Marshall
Electronics, beyond the time period described above.
An extra note about LCD displays: It is considered normal for a minimal amount of pixels, not to exceed three, to fail on the periphery of the display active viewing area. Marshall Electronics
has the option to reserve service for display pixel failure if deemed unobtrusive to effective use of the monitor by our technicians.
Due to constant effort to improve products and product features, specifications may change without notice.
Product Overview
Features
Specifications
Setup
Connectors
Front Panel Indicators and Controls
Menu Functions
PC Formats supported from VGA and DVI connectors
Video Formats Supported By Component and DVI inputs
Video Formats Supported By Composite and S-Video Inputs
Standard Accessories
Optional Accessories
Warranty
1
2
3
4
5
6
7
8
V-R151P
V-R151P
Users Guide
Users Guide
13
Warranty
9
10
11
12
13
12
Optional Accessories
3
5
Connectors
6
Front Panel Indicators and Controls
Marshall Electronics
V-Mount Battery Adapter
12 VDC from power supply
4 Pin Male XLR
Pin 4 - Pos
Pin 1- Neg
VESA 75mm
Attach Points
S-Video IN
4 Pin Din (Female)
Pin1 - GND
Pin2 - GND
Pin3 – Y in
Pin4 – C in
Composite
Video 75Ω
Audio L/R 8Ω
RF Tuner Input 50Ω
Pin1- Green
Pin2- Red
Pin3-Amber
Pin4 Gnd -
Pin5-
Pin6-
Pin7-
Pin8-
Pin 9-
Pin10-
Pin11-
Pin12-
Pin13-
Pin14-
Pin15-
Tally IN HD-15 Female
Pin1-Red IN
Pin2-Grn IN
Pin3-Blu IN
Pin4-
Pin5-
Pin6-Gnd
Pin7-Gnd
Pin8-Gnd
Pin 9-
Pin10-
Pin11-
Pin12-
Pin13- HSync
Pin14- VSync
Pin15-
XGA IN HD-15 Female
Power On/Off selection button
Illuminates dim red when power is applied.
Turns bright red when monitor is switched on
On Screen Display (OSD) MENU Activation Button
TALLY INDICATORS
Dual Function EXIT button
1- Cycles Input selection (Selection Displayed lower right of screen)
2- Exits OSD Menu Mode
UP/DOWN/LEFT/RIGHT menu selections for OSD functions
When TV is selected use UP/DOWN for channel selection
Use LEFT/RIGHT for speaker volume adjustment
7
Menu Functions
Note: MENU select will toggle through 5 menus, PICTURE, SCREEN, FUNCTION, SOURCE and TV
1. Picture Menu (Use UP/DOWN/LEFT/RIGHT buttons to select function)
TV S-Video Video PC
Brightness
99 99
Contrast
99 99
Sharpness
99 9
Tint
99 9
Phase
9
Color
99 9
Color temp
9
4
V-R151P Users Guide
V-R151P Users Guide
2. Function Menu (Use UP/DOWN/LEFT/RIGHT buttons to select function)
TV S-Video Video PC
Auto Confi gure
9
DPMS
999
Reset
99 99
OSD Time Out
99 99
Sleep Timer
9
Language
AUTO Confi gure – Used for PC signals to auto fi t image to screen.
DPMS – When selected to ON, the Digital Power Management System will place the monitor into standby when there is no
input signal for 12 seconds and will automatically turn on the monitor when a signal is applied to the last selected source.
Reset – Restores the monitor to factory settings
OSD TIME-OUT – Set time in seconds (0 to 60) for OSD to drop from screen after last button push
SLEEP TIMER – Used to automatically turn monitor off after programmed delay
Language – Not Used
3. TV SETUP MENU (Use UP/DOWN/LEFT/RIGHT buttons to select function)
TV S-Video Video PC
Auto Search
9
Manual Search
9
Auto Fine Tune
9
Fine Tune
9
TV Source
9
AUTO Search – Will scan through all channels to fi nd available signals and automatically program the tuner.
Manual Search – Use to scan individual channels to add or eliminate channels of the tuner
Auto Fine Tune – Set to ON for automatic adjustment of each channel to achieve the strongest signal.
Set to OFF to enable manual adjustment of the TV tuner.
Fine Tune – When AUTO FINE TUNE is off, this function will be enabled for manual adjustment of the TV tuner
TV Source – Select between off air signals (Channels 2-69) or RF Cable system (Channel 1-125)
Fine Tune Menu
4. Screen Menu (Use UP/ DOWN/ LEFT/ RIGHT buttons to select function)
TV S-Video Video PC
H-Position
9
V-Position
9
Frequency
9
V-Position – Use LEFT and RIGHT buttons to adjust horizontal position of the PC Image
H-Position – Use LEFT and RIGHT buttons to adjust wertical position of the PC Image
Frequency – Use LEFT and RIGHT buttons to adjust the pixel clock width of the PC Image
• XGA Resolution 1024 × 768 pixels, 2.4 million total RGB pixels produce 16.7 million colors
• 250 candela per meter² luminance
• Compact design fits in EIA standard rack 6U high
• VESA 75 mount for wall, ceiling or desk top
• Automatic Gamma Correction
• 16:9 or 4:3 aspects
• 125 Channel Cable Ready NTSC TV Tuner
• Self-powered 3 color tally system
• NTSC/PAL operation
• 170
° CRT style viewing angles
• 12 VDC 4-pin XLR power connector with external power supply
• V-Mount battery adapter
1
Product Overview
The V-R151P is a rack-mounted monitor with a 15”, 4:3 aspect ratio active matrix LCD/TFT module. Mounting can also be
achieved via a VESA 75 reinforced mount point on the rear of the unit or with the included rack ears. The display will produce a
high-resolution 1024W x 768H XGA image from a computer or display scaled video images. Television, Composite Video or Y/C
(S-video) images are displayed via a proprietary internal scaling LSI The unit is designed to fi t into an EIA standard 19” rack and
occupies 6RU of space. For ease of operation the V-R151P includes front mounted selector buttons for menu operations with On
Screen Menu Display (OSD) and “ON AIR” tally.
2
Features
2
5
V-R151P-Users Guide
V-R151P-Users Guide
Marshall Electronics
3
Specifications
Display (Viewing Area) 15” Diagonal (11.97” × 8.98”) (304.1mm x 228.1mm)
Resolution (Pixels) 1024H x 768V
Screen Format 4 x 3
Screen Treatment Anti-Glare and Anti-scratch Hard Coat
Dot Pitch 0.297 square pixel
Pixel Response 12ms Maximum - Black to White to Black (2.5ms rise, 9.5 ms decay)
Viewing Angle 85° (L/R), 50° (U), 60° (D) From Center
Brightness (in cd/m²) 250 cd/m²
Color Temp D-65
Color Gamut SMPTE/EBU
Backlight CCFL 50,000 hour
Contrast Ratio 450:1
Video Inputs System NTSC/PAL
TV Tuner System NTSC
Inputs 1 S-Video (4 Pin Mini Din), 1 Composite (RCA), 1 XGA (15P HD-15),
Audio L/R (RCA),RF (F-Type), Power (4 Pin Male XLR), Tally (15 Pin HD-15)
Rack Mount Dimensions 19.12”W × 10.5”H × 2.5”D (48.5cm x 26.7cm x 6.35cm)
Desk Top Dimensions 16”W x 10.5”H x 2.5”D (40.6cm x 26.7cm x 6.35cm)
Approx. Weight 8 lbs (5.7kg)
Power Consumption 40Watt Max 12 VDC from included power supply (V-PS12-5V1(XLR))
Operating Temperature 0°C to 50° C (Storage -20°C to +60°C)
4. Source Menu (Use UP/ DOWN/ RIGHT buttons to select function)
TV S-Video Video PC
Analog RBG (PC)
99 99
Composite Video
99 99
S-VHS Video
99 99
T V
99 99
Analog RGB – Select the on screen source display to be from the HD-15 PC connector on the rear of the unit. Audio speak-
ers will be from the red and white RCA connectors.
Composite Video – Select the on screen source display to be from the White RCA (Video) connector on the rear of the unit.
Audio speakers will be from the red and white RCA connectors.
S-VHS Video – Select the on screen source display to be from the White RCA (Video) connector on the rear of the unit.
Audio speakers will be from the red and white RCA connectors.
TV – Select the on screen display and speakers source input to be from the internal TV Tuner
Resolution H Frequency ( kHz ) V Frequency ( Hz ) Pixel Frequency ( MHz )
640x480 31.469 59.94 25.175
640x480 35.000 66.667 30.24
640x480 34.940 69.884 28.513
640x480 37.861 72.809 29.765
640x480 37.500 75.0 31.5
720x400 31.469 70.087 28.322
800x600 35.156 56.25 36.0
800x600 37.879 60.317 40.0
800x600 43.764 70.02 45.513
800x600 48.077 72.188 50.0
800x600 46.875 75.0 49.5
1024x768 48.780 60.001 64.11
1024x768 48.363 60.004 65.0
1024x768 56.476 70.069 75.0
1024x768 57.703 72.039 78.476
1024x768 60.030 75.029 78.75
1280x720 47.760 60.0 74.481
1280x768 47.700 60.0 80.136
1280x768 60.150 75.0 102.977
720x480 Interlaced 15.735 60/59.94 13.500
720x576 Interlace 15.735 50.0 13.595
4
Setup
1. Unpack the V-R151P and accompanying power supply. Physically inspect for any damage that may have occurred during
shipping. Should there be any damage, immediately contact Marshall Electronics at 800-800-6608. If you are not located
within the continental United States call +1 310-333-0606.
2. Install in your desired location.
3. Connect required cables for signal input and output.
4. Attach battery (Optional) or power connection from power supply to the back of the unit.
5. Plug the power supply into the A.C. source
6. Turn on the V-R151P by depressing the power switch located on the front of the unit.
Refer to Page 3 picture for location of switch settings.
7. Perform input selections and screen adjustments as detailed in following sections of this document
11
Standard Accessories
720x480 Interlaced 15.735 59.94 13.500
720x576 Interlace 15.735 50.0 13.595
Accessories Supplied with the V-R151P
• Users manual • “V” Mount battery adapter
• “Brick” type 12vdc power supply with 4 Pin Female XLR connector • VESA 75 Mount
8
PC Formats supported from VGA and DVI connectors
9
Video Formats Supported By Component and DVI Inputs
10
Video Formats Supported By Composite and S-Video Inputs
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Marshall Electronics LCD Rack Mounted Monitor V-R151P User manual

Marshall Electronics
Brand
Marshall Electronics
Model
LCD Rack Mounted Monitor V-R151P
Category
LCD TVs
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents