Star Trac Spinner NXT 7000 Owner's manual

Assembly & Setup

Star Trac Spinning

- Installation Checklist

Use the checklist below to ensure proper installation of Star Trac Spinning

bikes:

 All parts and hardware in the package are accounted for.

 Ensure front and back leg braces are secured to frame and blue loctite is used on all fasteners

 Check the seat to make sure it is leveled, tight and does not rotate or tilt. Tighten and adjust as

needed.

 Verify pedals are tightly secured to crank arms.

 Bottom bracket is properly tightened.

 Bottle cage tightly secured.

 Verify flywheel alignment and belt/chain tension. Lubricate and adjust chain as needed to ensure a

smooth ride. If belt is present, adjust tension as necessary and DO NOT lubricate

 Ensure that adjustment knobs (seat height, seat fore & aft, and handlebar) are properly secured and do

not interfere with range of motion.

 Test the handlebar post and seat post to make sure they move freely and are able to lock at different.

 If there is grease apparent in the threads of the pop pins for the handlebar or seat post, clean with

isopropyl alcohol before tightening

 Adjust the leveling feet to ensure the unit is stable and leveled.

 Overall visual & cosmetic inspection: All equipment is to be wiped down and checked for defects prior to

leaving the facility. Installer is to contact an authorized Core Health & Fitness representative while on site, if

there are any issues that have not been resolved.

STAR TRAC FITNESS 0 of 1 637-1587 Rev: B