2. JHS Pedals
  3. 410787 CRAYON Effect Pedal for Electric Guitar

JHS Pedals 410787 CRAYON Effect Pedal for Electric Guitar Operating instructions

  • Hello! I have reviewed the user manual for the JHS Pedals CRAYON, a British voiced preamp distortion pedal. This manual details its controls, including the MASTER, PRE-VOL, and TILT settings, as well as the HI-PASS filter and DIP switch options. I'm ready to answer any questions you have about the CRAYON and its capabilities.
  • What does the MASTER control do?
    How does the PRE-VOL control work?
    What is the purpose of the TILT control?
    What does the HI-PASS switch do?
    What does the DIP switch allow you to do?
    What type of power does the pedal require?
    Where are the input and output jacks located?
CONTROLS
MASTER - Controls the output volume. Left is less, right is more.
PRE-VOL - Works as a drive or fuzz control like turning up the pre-volume on a preamp. As you reach 75%
and above, the fuzz will begin to gate out when you pick the strings harder.
TILT - Active tone control that is at when the knob is at 50%. When turned to the left, it will boost bass and
simultaneously cut treble. When turned to the right, it boosts treble and cuts bass.
HI-PASS - Cuts your low end with a ick of the switch for the ability to cut through the mix or get lo- sounds.
DIP SWITCH - Allows for either 200Hz or 750Hz cut for the Hi-Pass.
JACKS
INPUT - ¼” jack on the right side of the pedal.
OUTPUT - ¼” jack on the left side of the pedal.
POWER - Uses 9V DC Negative Center. Do not use more than 9V DC. Your warranty will be voided.
15mA consumption.
CRAYON
British voiced preamp distortion, fuzz, overdrive, and boost in a
versatile small footprint that follows in the shadow of the Colour Box.
Looking for a different dirt sound? Look no further.
/