2. Western
  3. LED Work Light Polarity #78377

Western LED Work Light Polarity #78377 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Western LED Work Light Polarity #78377 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
78377
INSTALLATION INSTRUCTIONS
1. Follow these instructions if you determine your
existing wiring may require reversing the polarity
of the work light connector.
2. You will need the following:
• Flat screwdriver
• Terminal extraction tool or
jumbo smooth paperclip
• Work light connector
A DIVISION OF DOUGLAS DYNAMICS, LLC
LED Work Light
Reversing Polarity
September 1, 2022
Lit. No. 88961, Rev. 00
4. Note the wire color at positions A and B.
5. Insert terminal extraction tool or paperclip into
the connector body as shown to a depth of about
5/16" to release the terminal lock on the red wire.
3. Gently pry secondary lock away from each side of
connector body and set it aside for reuse.
78377
Lit. No. 88961, Rev. 00 2 September 1, 2022
The company reserves the right under its product improvement policy to change construction or design details and furnish equipment when
so altered without reference to illustrations or specications used. This equipment manufacturer or the vehicle manufacturer may require or
recommend optional equipment for snow removal. Do not exceed vehicle ratings with a snowplow. The company oers a limited warranty for
all snowplows and accessories. See separately printed page for this important information.
Printed in U.S.A.
6. Gently pull the red wire out of the connector body.
It should come free with ease, so if it isn't you may
need to reposition the extraction tool to ensure the
terminal lock tab is released. Damage may occur if
excessive force is used.
7. Repeat Steps 5 and 6 for the black wire.
8. Reinsert the terminals into the connector body
making sure to swap the positions of the red and
black wires from their initial positions noted in
Step 4. An audible click may be heard.
9. While holding harness as shown, reattach
secondary lock to connector body.
/