Astria Fireplaces Compass DLX Instruction Sheet

Type
Instruction Sheet

This manual is also suitable for

INSTALLATION INSTRUCTIONS FOR ELBOW HEAT SHIELD KIT
[For Use with Astria and Superior® DV Fireplaces that require this shield when an elbow is used directly off unit] GeminiDLX
series, DRT3500 series, CompassDLX, Altair-C series.
ELBOW HEAT SHIELD KIT
901041-00
Rev. NC 11/2019
HEARTH PRODUCTS
KITS AND ACCESSORIES
PACKAGING LIST
2 ea. Elbow shields
4 ea. Screws
1 ea. Installation Instructions
TOOLS / SUPPLIES NEEDED
Safety Glasses
Protective Work Gloves
Power Drill, and 5/16” Hex Bit Tool
GENERAL INFORMATION
Refer to the installation instruction manual provided with your
fireplace to determine if the elbow shield is required.
READ ALL THE STEPS BEFORE STARTING THE INSTALLATION
THE FIREPLACE MUST BE OFF AND COLD BEFORE BEGINNING.
ALL WARNINGS, PRECAUTIONS AND INSTRUCTIONS IN THE
INSTALLATION AND OPERATION MANUAL PROVIDED WITH
THE APPLIANCE APPLY TO THESE INSTRUCTIONS.
If you encounter any problems, need clarification of these
instructions or are not qualified to properly install this kit,
contact you local distributor or dealer.
If any of these parts are missing or damaged, contact your
dealer or IHP.us.com for referral information.
Table 1
Elbow heat shield kit
Cat. No. Model Description
F4066 SV4.5EHSK Elbow Heat Shield Kit
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Installation Instructions
901041-00NC 11/2019
Innovative Hearth Products
Elbow Heat Shield Kit
Printed in U.S.A. © 2019 Innovative Hearth Products
P/N 901041-00 Rev. NC 11/2019
Innovative Hearth Products (IHP) reserves the right to make changes at any time, without
notice, in design, materials, specifications, and prices, and also to discontinue colors, styles,
and products. Consult your local distributor for fireplace code information.
1769 East Lawrence Street • Russellville, AL 35654
INSTALLATION INSTRUCTIONS
Figure 1 - Elbow Heat Shield Installation
STEP 1. Locate the two (2) flat elbow
shields.
STEP 2. Bend the three (3) tabs 90
degrees as shown below.
STEP 3. Attach the two (2) shields, as
shown, with screws.
STEP 4. Attach the two (2) shields to the fireplace. STEP 5. Fold down tab to support rear of shield.
  • Page 1 1
  • Page 2 2

Astria Fireplaces Compass DLX Instruction Sheet

Type
Instruction Sheet
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI