Yale YRC226-ZW2 User manual

Category
Security access control systems
Type
User manual
1
P/N - - - Rev GYRL EMICL TSINSTL FUL
Retrofitting or modifying this product may impact fire rating, safety features and warranty.
Consult with code specifications to ensure compliance with all codes and ratings.
Yale Assure Lock
®®
Electronic Interconnected Touchscreen
Installation and Programming Instructions
(YRC226/YRC426/YRC620/YRC622)
®
Network Module
(Optional - Not
available on
YRC620)
Before you begin
for step-by-step installation
instructions & to register
your product
DOWNLOAD
THE BILT APP
4" Touchscreen Shown - 5.5" Available
Inside
of Door
Outside
of Door
2
P/N - - - Rev GYRL EMICL TSINSTL FUL
Before You Begin
1-3/8" (35mm) Min to
1-3/4" (44.5mm) Max
4-1/2"
(114) Min
x1x2 x8
Network Module
(Optional - Not
available on
YRC620) 3/32"1/8"
Template
x2 x2 x2
#2
1/8" 2-1/8"
1
1"
3
P/N - - - Rev GYRL EMICL TSINSTL FUL
Mark Door Reference Lines
C
L
R
E
M
O
V
E
Template
EXISTING
2-3/8" or 2-3/4"
Backset
4
P/N - - - Rev GYRL EMICL TSINSTL FUL
1Preparing Door
(if necessary)
!
Drill holes 1/2 way thru
door then complete
from other side to
prevent splitting.
Ø2-1/8" 2-3/8"
or
2-3/4"
Ø1"
Template
4"
or
5.5"
5
P/N - - - Rev GYRL EMICL TSINSTL FUL
2Installing Strike Plates
Door Frame
Inside
of Door
Frame
1" Dia. x
1"Deep
1" Dia. x
1/2"Deep
Frame
7-16 / 8-32 x 1" UNCWS
x4
Left Hand “ ”, Hinges Left.LH
Open Inward.
Left Hand Reverse " ", Hinges Left.LHR
Open Outward.
Right Hand " ", Hinges Right.RH
Open Inward.
Right Hand Reverse " ", Hinges Right.RHR
Open Outward.
The hand of a door is determined from the secure side of the
door. The term "secure" means the side from which you initially
unlock and enter.
Determining Handing
6
P/N - - - Rev GYRL EMICL TSINSTL FUL
7
P/N - - - Rev GYRL EMICL TSINSTL FUL
3Changing Handing
(if necessary)
4-24 x 1/4" PPHMS
4" Left Hand to 4" Right Hand Shown
x2
3
!
DO NOT TAMPER
WITH OR LOOSEN
E-CLIP AND ITS
ASSEMBLY
!
DO NOT LOOSEN
THESE 6 SCREWS
OR REMOVE
COVER
Changing Handing
(if necessary)
continued
3
8
P/N - - - Rev GYRL EMICL TSINSTL FUL
9
P/N - - - Rev GYRL EMICL TSINSTL FUL
Lockset Handing Configurations
4" Left Hand
For 5.5"
For 4"
4" Right Hand
For 5.5"
For 4"
After handing is changed, check that lever and thumbturn rotate freely.
Test Lever and Thumbturn
10
P/N - - - Rev GYRL EMICL TSINSTL FUL
4Installing Fire Cups
Inside of Door
Both Fire Cups and a markedUL
Latchbolt must be used to
qualify for listing.UL
!
11
P/N - - - Rev GYRL EMICL TSINSTL FUL
5Adjusting Deadbolt Latch
(If adjustable deadbolt latch provided)
O
optional
default
UP
2-3/8" position
UP
2-3/4" position
Press
Pull
12
P/N - - - Rev GYRL EMICL TSINSTL FUL
6Installing Deadbolt Latch & Latchbolt
x4
7-16 / 8-32 x 1" UNCWS
Curved edge of latchbolt
faces direction door closes.
!
Choose latchbolt
based on backset.
(2-3/8" or 2-3/4")
Inside of Door
Bolt must be in
retracted (unlocked)
position before
installing.
!
Ensure arrow
stamped on deadbolt
is .UP
!
UP
13
P/N - - - Rev GYRL EMICL TSINSTL FUL
M6x55 PPHMS
U
P
Inside of Door
x2
7Installing Exterior Deadbolt
UP
Bolt must be in
retracted (unlocked)
position.
!
14
P/N - - - Rev GYRL EMICL TSINSTL FUL
8Installing Lock Chassis
10-32 x 1-1/2" PPHMS
Inside of Door
x2
U
P
15
P/N - - - Rev GYRL EMICL TSINSTL FUL
9Securing Back Plate to Door
x2
#6-32 x 1/2" POHMS
!
!
#6-32 x 1/2" POHMS
screws must be used
to qualify for listing.UL
Drill two
pilot holes
Ø1/8"
x 1/2" deep
Inside of Door
U
P
16
P/N - - - Rev GYRL EMICL TSINSTL FUL
Testing Deadbolt & Latchbolt Operation
Outside of Door
17
P/N - - - Rev GYRL EMICL TSINSTL FUL
10 Remove Battery Cover
Loosen screw
to remove cover.
18
P/N - - - Rev GYRL EMICL TSINSTL FUL
11 Attaching the Cable Assembly
Cable must be routed
as shown to avoid
interference with
movement
of lock.
!
U
P
Inside of Door
Align wire connectors so
that tabs slide into slots. Tug
gently on cables to test that
connectors are secure.
!
Tab
Slot
Tab
Slot
19
P/N - - - Rev GYRL EMICL TSINSTL FUL
12 Installing Interior Lock
Turn
thumbturn
to adjust slot
orientation.
!
!
U
P
Orientation must match.
Do not fasten lock to back plate
until properly fitted.
Inside of Door
20
P/N - - - Rev GYRL EMICL TSINSTL FUL
12 Installing Interior Lock continued
10-32 x 5/8" POHMS
x1
6-32 x 1" PPHMS
x2
Inside of Door
DO NOT
LOOSEN
THIS SCREW
!
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38
  • Page 39 39
  • Page 40 40
  • Page 41 41
  • Page 42 42
  • Page 43 43
  • Page 44 44
  • Page 45 45
  • Page 46 46
  • Page 47 47
  • Page 48 48
  • Page 49 49
  • Page 50 50
  • Page 51 51
  • Page 52 52
  • Page 53 53
  • Page 54 54
  • Page 55 55
  • Page 56 56
  • Page 57 57
  • Page 58 58
  • Page 59 59
  • Page 60 60
  • Page 61 61
  • Page 62 62
  • Page 63 63
  • Page 64 64
  • Page 65 65
  • Page 66 66
  • Page 67 67

Yale YRC226-ZW2 User manual

Category
Security access control systems
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI