2. JIECANG
  3. AC Tubular Motor
AC Tubular Motor

JIECANG AC Tubular Motor User manual

  • Hello! I've read the provided user manual for the Tubular Motor, specifically model JCA 35. This manual covers instructions for setting mechanical limits. It also has a section on how to operate the motor and troubleshooting common issues you might encounter. I'm ready to answer your questions about this device.
  • What should I do if the motor runs only in one direction after powering on?
    What could be the cause of the motor not running or starting slowly?
    What to do if the motor suddenly stops?
AC Tubular Motor with Mechanical Limit
User Manual
01 Product Info
02 Caution!
03 Instructions
a.Upper&Lower Limits Setting
wire.
04 Troubleshooting
Note: Use remote controller to operate the motor if an external receiver is connected.
If external switch is connected, operate the motor directly by the switch.
When motor is not working, do not turn the hole with hexdriver.
1.Adjust the voltage to rated
data
The motr has exceeded termal
overheat protection (4 minutes)
Wait for the motor to cool
down for approximately 20
minutes
1.The crown and drive adapter
are not well adapterd to tube
2.The driving tube is too long,
cused the brackets are too
tightly
Inside limit switch of motor
doesn't open
1.Change correct size crown
and drive adapter
2.If idler is active, make
driving tube shorter to
avoid the tight status
Stop turning the hole, and
press STOP on remote
controller or switch
Stop turning the hole, and
press STOP on remote
controller or switch
/