Bercomac 700707-1 User manual

Brand: Bercomac

Model: 700707-1

Type: User manual

Instructions

FOR KIT

700707-1

LIFT LINKS FOR COMPACT SNOWBLOWER

#700707-1

INSTALLATION

STEP 1: REMOVE THE BELT GUARD:

STEP 2: REMOVE THE TENSION ARM AND THE PULLEYS:

IMPORTANT: Before installing the update kit, follow all safety instructions and indications by

reading and understanding all of the snowblower and the subframe owner’s manual.

Remove all parts shown in this step, except 2 and 4 (these parts

are to be discarded), they will be re-installed in the step 4.

Memorize the position of the parts.

R-29032016

FOR KIT

700707-1

STEP 3: INSTALL THE LIFT LINKS:

Install the links as shown. Do the same on both sides. Make

sure not to reverse the lift links.

R-29032016

9

NOTE: If there are no drilled holes in the hitch (item 9), use the

drilling template included with these instructions to make some.

STEP 4: INSTALL THE NEW TENSION ARM AND RE-

INSTALL THE PULLEYS:

Re-install the parts removed in step 2 (except the old tension arm

and handgrip), make sure to install the new parts (items 1 & 2) in the

table below . The nylon insert lock nuts 3/8” n.c. that are supplied

with the kit are there to replace those removed in step 2.

Note: Tighten the carriage bolt 3/8” n.c. x 1 1/4” enough to allow the

tension arm to pivot freely.

STEP 5: RE-INSTALL THE BELT GUARD:

FOR KIT

700707-1

STEP 6: INSTALL THE SNOWBLOWER:

Refer to the manual of the snowblower to install the snowblower

on the hitch.

Insert the links (one of each side) in the ends of the actuators

and install the following parts in the indicated direction.

Note: As needed, extend actuators with the switch to be able to

insert the pins.

R-29032016

FOR KIT

700707-1

R-29032016

1
2
3
4

Bercomac 700707-1 User manual

Brand: Bercomac

Model: 700707-1

Type: User manual

Download PDF

Related papers

Other documents