V3 ENGLISH 17-0873
4 Repeat steps 2 and 3 to remove the pin from the other side of the
link, and then remove the link. Continue removing pins and links
until the band is the desired length.
5 Press the two unattached links together, with the arrows on the
backside of the links facing the same direction, and slide a pin into
the hole that is on the opposite side of the arrows.
6 Place the watch band into the slot with the arrows on the backside
of the band face up and pointing toward the pin-removal rod. Align
the pin with the rod, and then turn the knob clockwise to push the
pin into the watch band link.
TIP: Store the
unused pins
and links.
REPLACING THE PIN-REMOVAL ROD
1 Open the bottom cover to nd the two spare pin-removal rods in
the tool.
2 Pull out the current removal rod with pliers and replace with a
new one.
ONE-YEAR LIMITED WARRANTY
CONTACT PLATINUM
For customer service, call 1-800-499-3964
Apple Watch is a trademark of Apple Inc., registered in the U.S. and other countries.
The Pt logo is a registered trademark of Best Buy.
PLATINUM is a trademark of Best Buy and its aliated companies
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2017 Best Buy. All rights reserved.
Made in China