Page is loading ...
59" LIGHTED SNOWMAN
Part
Description
Illustration
Qty
A
Hat
1
B
Lower Body
1
C
Upper Body
1
D
Scarf
1
E
Arms
2
F
Bird
2
G
Plastic Ties
H
Ground Stake
MAKE SURE TO FOLLOW THE STEPS BELOW
FOR A SUCCESSFUL & EASY ASSEMBLY
TIP: To ensure the final unit is secure and sturdy it is highly recommended to
secure each component with the zip ties provided after connecting each
component together in the steps.
TO ASSEMBLE
1. Remove the twisted ties from the folded frame.
NOTE: Some parts are connected by the strings of lights and should not be completely separated.
2. Put all the parts on a leveled ground surface and in the right order.
3. Insert the prongs on the bottom of the Upper body (C) into the corresponding rings of the Lower
body(B). (see Fig.1)
Fig.1
4. Insert the prongs on the Arms (E) into the corresponding rings of the Upper body(C). (see Fig.2)
5. Insert the prong on the Scarf(D) into the corresponding ring of the Upper body(C). (see Fig.2)
Fig.2
6. Insert the prong on the Bird(F) into the corresponding ring of the Arm(E). (see Fig.3)
7. Insert the prong on the bottom of the Hat(A) into the corresponding ring of the Upper body(C). (see
Fig.3)
8. Insert the prong on the Bird(F) into the corresponding ring of the Hat(A). (see Fig.3)
9. VERY IMPORTANT:Secure the installing points with plastic ties(G) and secure the base to the
soft ground by fully inserting Ground stakes(H) into the ground.
10. Plug the light set into a standard 120-volt AC electrical outlet.
/
