2. Mueller
  3. M2 Gear Pack Pneumatic Console
M2 Gear Pack Pneumatic Console

Mueller M2 Gear Pack Pneumatic Console User guide

  • Hello! I've reviewed the user guide for the Mueller M2 Gear Pack REVIVE Pneumatic Console. This document explains how to operate the device, including setting treatment time and pressure, using the air connection ports, and monitoring the battery status. I'm ready to answer any questions you have about this device and its features.
  • How do I start the treatment?
    How do I pause the treatment?
    How do I set the treatment time?
    How do I adjust the treatment pressure?
3
8
5
17
(On Back)
4
2
6
9
M2 GEAR PACK — PNEUMATIC CONSOLE QUICK START GUIDE
1
2
3
4
5
6
7
8
9
POWER SWITCH
Used to turn On/Off the M2 pneumatic console
START/STOP BUTTON
Use to start or stop treatment. To pause treatment, press start/stop
and hold for 3 seconds. Press start/stop again to resume
BATTERY STATUS
Indicates how much charge is in battery
TIME BUTTON
Used to set length of treatment time
STATUS INDICATOR
•
Power is on
•
Treatment in progress
• Error indication
PRESSURE DIAL
Light – 20 to 35 mmHg
Medium – 40 to 65 mmHg
Intense – 70 to 100 mmHg
DC ADAPTER SOCKET
Used for connecting the universal power adapter
AIR CONNECTION PORTS (2)
Used to connect garments to the pneumatic console
AIR CONNECTION BLOCKER PLUG
Use blocker plug when only one garment is in use
Scan for complete
instructions
Mueller Sports Medicine, Inc., One Quench Dr., P.O. Box 99, Prairie du Sac, WI 53578, USA
800-356-9522, Fax 800-852-4334, www.MuellerSportsMed.com L98207MR-A
M2 GEAR PACK — PNEUMATIC CONSOLE QUICK START GUIDE
USING THE REVIVE M2 PNEUMATIC CONSOLE
1. Place the REVIVE console on a flat stable surface and insert the power
adapter into the DC adapter socket on the console to charge the battery.
Power Switch must be on to charge the battery
2. Put on the garment and connect the garment hoses
3. Insert the Blocker Plug to block the unused air outlet for single garment use
4. Set treatment pressure by pressing in and turning pressure knob
(Recommended pressure for first time users is 40 mmHg)
5. Press the Time button to set the treatment
time to 15 minutes, 30 minutes, 45 minutes,
60 minutes or continuous mode
6. Select the HOLD Time by holding down the
Time button
• Short HOLD – Press for 3 seconds (1 beep)
• Medium HOLD – Release and press again
for 3 more seconds (2 beeps)
• Long HOLD – Release and press again for
3 more seconds (3 beeps)
7. Start the treatment by pressing the Start/Stop button
CHARGING THE REVIVE M2 PNEUMATIC CONSOLE
• Turn on the Power Switch to enable charging the battery
• Turn Off the Power Switch to conserve battery power when not charging
or not using the REVIVE M2 pneumatic console
• Battery level is continuously displayed by the battery status indicators
Time
Minutes
Time
Minutes
Scan for complete
instructions
/