Eureka SQ Operating instructions

Hello! I've reviewed the user manual for the Eureka Timberline SQ Vestibule Accessory. This document provides step-by-step instructions on how to install the vestibule onto your tent using features like shock cords, J-hooks, and velcro tabs. I am ready to answer your questions about the product and its setup.
What should I do before installing the vestibule?

How do I attach the top web?

Where do the Velcro tabs go?

How do i fit the vestibule grommet?

What is the last step in setting up the vestibule?

Timberline SQ Vestibule Accessory

1. Begin with your tent already set up

and staked.

2. Push the top web through

the center of the shock

cord. Wrap it up and over

the black hub. Secure with

the toggle.

4. There are a pair of

Velcro® tabs on each

side of the vestibule.

Wrap them around

the tent pole.

Note: it’s easier to install the vestibule if you release the

“wings” from their stakes and fold them back over the

poles.

3. Hang the J-Hook onto

the web loop near

the end of the ridge

pole extension.

5. The vestibule and tent webs

share the same pole. Lift the

pole and fit the vestibule

grommet underneath the

tent grommet.

6. Pull out and stake down

the two front web loops.

Restake the “Wings”

and Your Vestibule is

Ready!