2. ZENDURE
  3. SuperBase Pro 2000
SuperBase Pro 2000

ZENDURE SuperBase Pro 2000 Operating instructions

  • Hello! I've reviewed the user manual for the SuperBase Pro 2000 power station. This manual provides instructions on how to upgrade the firmware for your device using the Zendure App. The document outlines the pre-upgrade requirements, along with step-by-step instructions for the update process. I'm ready to answer your questions about the device and the update procedure. How can I assist you today?
  • What should I confirm before upgrading the firmware?
    What app is required to upgrade firmware?
    What is the steps to upgrade?
Important
1, Kindly advise you to upgrade the firmware before using the Power Station.
2, How to upgrade the firmware
The following are instructions for updating the firmware for the SuperBase Pro 2000.
Confirm before upgrading:
1: The current device has enough power, at least not less than 5%.
2: The current device can be started and used normally.
3: The current network or Wi-Fi hotspot signal is strong.
Steps to upgrade:
1: First, please download the Zendure APP, and refer to the "Zendure App User
Guide" to register an account and log in. If you cannot receive the verification
information during registration, please check the spam mailbox.
2: Refer to this video to bind your SuperBase Pro and APP. And please make sure the
Wi-Fi hotspot is 2.4GHZ.
3: After binding the device to the APP, you can see the current information of the
device on the System Settings page of the APP. At this point you can refer to
the video in step 2 to update the firmware.
After completing the above steps, you can start to experience the latest firmware.
Zendure App User Guide:
https://zendure.com/pages/download-center
Video：
https://drive.google.com/file/d/1s-uW6HG6vFg6gb4-8YRKl-Xm6K4jCGAo/view
/