The Tomahawk Early Entry Concrete Saws’
default blade setting is adjusted to the max
blade depth of 1-3/16” (ASTM Standard
Specification for Portland Cement). If a
shallower cut is desired, follow these steps:
Loosen the depth adjustment nut (1) above
the front right wheel, counter-clockwise with
a 13mm wrench.
Turn the depth stop adjustment bolt (2)
clockwise with a Size 5 Metric Allen wrench.
Each full revolution of the bolt will reduce the
cut depth by 1/8".
Make sure the rear wheels are flat on the
ground by pushing down on the rear of the
main frame.
Follow an existing saw joint cut for
approximately one foot to confirm that the
proper/desired cut is achieved.
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI